Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Two green circuit-board SODIMM modules with black chips and gold edge connectors

NEMIX RAM

NEMIX RAM 16GB (2x8GB) DDR4 2666MHz CL19 SODIMM Kit for POSIFLEX RT-2016-G2

SKU CH-2Z1S-WM8S1

A 16 GB DDR4 SODIMM kit (2 × 8 GB) running at 2666 MHz CL19, built for the POSIFLEX RT-2016-G2 terminal

  • Capacity16GB (2 x 8GB)
  • SpeedDDR4 2666 (PC4 21300)
  • ECCNo
  • Buffered/RegisteredUnbuffered
  • ChipsetMajor OEM Samsung, Micron, Hynix
  • Voltage1.20V
  • 16 GB dual-channel kit doubles usable memory for POSIFLEX RT-2016-G2 terminals
  • DDR4 2666 MT/s speed matches system spec for stable operation
  • CL19 latency and 1.2 V voltage keep power draw low
  • 260-pin SODIMM form factor fits the terminal's memory slots exactly
  • Built with major-brand DRAM chips and stress-tested for reliability

System-specific DDR4 SODIMM kit

This NEMIX RAM kit supplies 16 GB of DDR4 2666 memory in two 8 GB SODIMM modules built for the POSIFLEX RT-2016-G2 terminal. The unbuffered non-ECC design matches the platform's standard memory architecture.

Low-voltage operation at CL19

Each module runs at 1.2 V with a CAS latency of 19 and a 2Rx8 rank structure. The components use major OEM DRAM from Samsung Micron or Hynix and carry no heat spreader, keeping the profile thin for the terminal's internal slot layout.

Direct replacement for factory memory

The kit replaces the original SODIMM pair in the POSIFLEX RT-2016-G2 when the system needs more capacity than the stock configuration provides. It is not suited for devices that require ECC registered modules or a different pin count.

Helstu kostir

  • 16 GB dual-channel kit doubles usable memory for POSIFLEX RT-2016-G2 terminals
  • DDR4 2666 MT/s speed matches system spec for stable operation
  • CL19 latency and 1.2 V voltage keep power draw low
  • 260-pin SODIMM form factor fits the terminal's memory slots exactly
  • Built with major-brand DRAM chips and stress-tested for reliability

Tæknilýsing

BrandNEMIX RAM
SeriesPOSIFLEX POS Series Point of Sale Kiosk Memory
ModelPOSIFLEX POS DDR4 2666MHZ Non-ECC Unbuffered SODIMM
Part NumberMS21300-828K2
Capacity16GB (2 x 8GB)
SpeedDDR4 2666 (PC4 21300)
ECCNo
Buffered/RegisteredUnbuffered
ChipsetMajor OEM Samsung, Micron, Hynix
Voltage1.20V
Compatible SystemPOSIFLEX POS
CAS LatencyCL19
Heat SpreaderNo
Type260-Pin DDR4 SODIMM
Rank2Rx8
FeaturesDDR4 Non-ECC Unbuffered SODIMM Motherboard Compatible
Package Content16GB (2X8GB) DDR4 2666MHZ PC4-21300 2Rx8 1.2V CL19 260-PIN Non-ECC Unbuffered SODIMM KIT

Spurningar um þessa vöru

How do I install the 260-pin SODIMM modules in the POSIFLEX RT-2016-G2 and what step is often missed?

Power off and unplug the terminal, open the memory compartment, insert each module at an angle until the gold contacts are fully seated, then press down firmly until the side clips click — the step often missed is not pressing hard enough to engage both clips.

What maintenance or replacement will the DDR4 2666 CL19 kit need over time?

No scheduled maintenance is required; the modules have no heat spreader and run at 1.20 V, so only replace them if a memory test reports errors or you upgrade capacity.

What limit appears first when the POS terminal runs sustained workloads with this memory?

The CL19 latency at 2666 MT/s sets the throughput ceiling; under continuous load the memory bus saturates before thermal throttling becomes a factor.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.