Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Green 288-pin DDR4 RDIMM module without heat spreader

NEMIX RAM

NEMIX RAM 16GB DDR4 2933 ECC RDIMM 1Rx4 CL21 1.2V 288-pin HPE DL325 G10

SKU CH-QCS3-3SBC4

16 GB DDR4-2933 ECC registered DIMM for HPE ProLiant DL325 G10 servers

  • Capacity16GB
  • SpeedDDR4 2933 (PC4 23400)
  • ECCYes
  • Buffered/RegisteredRegistered
  • ChipsetMajor OEM Samsung, Micron, Hynix
  • Voltage1.20V
  • 16GB capacity for demanding server workloads
  • DDR4 2933MHz speed enables fast data throughput
  • ECC registered design protects data integrity
  • CL21 latency at 1.2V for efficient operation
  • 288-pin RDIMM built for HPE DL325 G10

HPE DL325 G10 Compatible ECC RDIMM

This NEMIX RAM module is a 16GB DDR4 2933 registered DIMM with ECC. It is built for the HPE ProLiant DL325 G10 server and similar enterprise platforms that require registered memory with error correction.

Suited for single-module upgrades on qualified HPE

It fits administrators adding capacity to a DL325 G10 or compatible HPE system that accepts 1Rx4 registered ECC modules. It is not for workstations or desktops that only support unbuffered UDIMMs, nor for boards that cannot address a 16GB rank.

1Rx4 registered ECC at 1.2V decides fit

The module uses a single-rank x4 organisation, CL21 latency and 1.2V operation on a 288-pin DDR4 interface. That combination determines whether the server memory controller will initialise the DIMM correctly.

Helstu kostir

  • 16GB capacity for demanding server workloads
  • DDR4 2933MHz speed enables fast data throughput
  • ECC registered design protects data integrity
  • CL21 latency at 1.2V for efficient operation
  • 288-pin RDIMM built for HPE DL325 G10

Tæknilýsing

BrandNEMIX RAM
SeriesHPE Server/Workstation Compatible Series Memory
ModelHPE DDR4 2933MHZ ECC RDIMM Registered Server Memory
Part NumberMR23400-614K1
Capacity16GB
SpeedDDR4 2933 (PC4 23400)
ECCYes
Buffered/RegisteredRegistered
ChipsetMajor OEM Samsung, Micron, Hynix
Voltage1.20V
Compatible SystemHPE
CAS LatencyCL21
Heat SpreaderNo
Type288-Pin DDR4 RDIMM
Rank1Rx4
FeaturesDDR4 ECC Registered RDIMM Server Motherboard Compatible
Package Content16GB (1X16GB) DDR4 2933MHZ PC4-23400 1Rx4 1.2V CL21 288-PIN ECC RDIMM Registered Server Memory

Spurningar um þessa vöru

How do I install this 288-pin DDR4 RDIMM in an HPE ProLiant DL325 G10 and what step is often missed?

Power down the server, open the chassis, align the notch on the 288-pin module with the slot key, press firmly until both retention clips click, then verify in BIOS that the 16GB 1Rx4 module is recognised at 2933 MT/s with ECC active.

What maintenance or replacement will this ECC registered module need over its service life?

No routine maintenance is required; the module has no heat spreader and runs at 1.2V, so keep server airflow clean and replace only if ECC correctable-error counts rise or a DIMM fails POST.

What limit appears first when this CL21 2933 MT/s RDIMM runs sustained workloads?

The CAS latency of 21 cycles at 2933 MT/s sets the baseline access latency; under continuous load the memory controller’s thermal and power envelope will throttle before the DRAM itself reaches a hard limit.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.