Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Two green DDR5 UDIMM modules without heat spreaders

NEMIX RAM

NEMIX RAM 32GB (2x16GB) DDR5 5600 CL46 1.1V UDIMM for ASRock IMB-1315/1318 memory upgrade

SKU CH-PH6P-0CGZA

32 GB DDR5 kit with two 16 GB modules at 5600 MT/s, CL46 and 1.1 V for ASRock IMB-1315 and IMB-1318 boards

  • Capacity32GB (2 x 16GB)
  • SpeedDDR5 5600 (PC5 44800)
  • ECCNo
  • Buffered/RegisteredUnbuffered
  • ChipsetMajor OEM Samsung, Micron, Hynix
  • Voltage1.10V
  • 32 GB total capacity from two 16 GB modules
  • DDR5 5600 speed rated at PC5-44800 bandwidth
  • Low 1.10 V operating voltage for efficient power use
  • CL46 CAS latency tuned for responsive operation
  • Validated for ASRock IMB-1315 and IMB-1318 motherboards

NEMIX RAM 32GB DDR5 kit for ASRock IMB-1315

This 32 GB kit contains two 16 GB DDR5 UDIMMs rated at 5600 MT/s with CL46 latency. It is built specifically for ASRock Industrial Micro-ATX motherboards IMB-1315 and IMB-1318. The modules are non-ECC, unbuffered and use 1Rx8 organisation.

1.10 V operation with no heat spreader

Running at 1.10 V, the kit draws minimal power and produces little heat during typical workloads. Without a heat spreader the modules rely on case airflow, keeping acoustic output low in a properly ventilated chassis.

288-pin DDR5 form factor fits two DIMM slots

The 288-pin design installs directly into the board's two UDIMM slots, leaving no additional slots free for expansion. Builders needing more than 32 GB or requiring ECC support must choose a different platform.

Helstu kostir

  • 32 GB total capacity from two 16 GB modules
  • DDR5 5600 speed rated at PC5-44800 bandwidth
  • Low 1.10 V operating voltage for efficient power use
  • CL46 CAS latency tuned for responsive operation
  • Validated for ASRock IMB-1315 and IMB-1318 motherboards

Tæknilýsing

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Memory
ModelDDR5 Non-ECC Unbuffered UDIMM Memory
Part NumberMD44800-618K2
Capacity32GB (2 x 16GB)
SpeedDDR5 5600 (PC5 44800)
ECCNo
Buffered/RegisteredUnbuffered
ChipsetMajor OEM Samsung, Micron, Hynix
Voltage1.10V
Compatible SystemASRock Industrial
CAS LatencyCL46
Heat SpreaderNo
Type288-Pin DDR5 UDIMM
Rank1Rx8
FeaturesDDR5 Non-ECC Unbuffered UDIMM Motherboard Compatible
Package Content32GB (2 x 16GB) DDR5 5600MHz PC5-44800 1Rx8 1.1V 288-PIN Non-ECC UDIMM KIT

Spurningar um þessa vöru

How do I install the 288-pin DDR5 UDIMM modules on the ASRock IMB-1315 motherboard, and what step is often missed?

Align the notch on each 1Rx8 module with the slot key, press down firmly until both retention clips click shut, then verify in BIOS that both 16GB sticks are detected at 5600 speed.

What maintenance or replacement will the NEMIX RAM kit need over its service life?

No scheduled maintenance is required; the modules have no heat spreader and run at 1.10V, so only replace them if a memory test reports errors or you need more than 32GB capacity.

What limit appears first when the DDR5 5600 CL46 memory runs under sustained load?

The CAS latency of CL46 at 1.1V sets the timing ceiling; sustained workloads will hit this latency bound before voltage or thermal limits become a factor.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.