Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Green printed circuit board with gold edge contacts and black memory chips on both sides

OWC

OWC 16GB DDR4 2400MHz CL17 ECC Registered RDIMM 2R4D42R816GB

SKU CH-GR34-4W97W

16 GB DDR4 ECC registered DIMM at 2400 MHz CL17 for select Supermicro server boards

  • Capacity16GB
  • Type288-Pin DDR4 ECC RDIMM
  • SpeedDDR4 2400 (PC4 19200)
  • CAS LatencyCL17
  • Voltage1.2V
  • ECCYes
  • ECC protection prevents data corruption in critical workloads
  • Registered design stabilises signal integrity for dense server configurations
  • 2400 MHz DDR4 speed delivers 19200 MB/s bandwidth for responsive multitasking
  • 16 GB capacity expands memory headroom for virtualisation and large datasets
  • Validated for Supermicro X10DR series motherboards ensuring drop-in compatibility

16GB DDR4 ECC Registered RDIMM

This 16GB DDR4 2400MHz CL17 ECC Registered RDIMM operates at 1.2V with a 288-pin interface. It is designed for server and workstation platforms that require registered memory with error correction. The module uses a 2Rx8 rank configuration and has no heat spreader.

Suits Supermicro X10DR motherboards only

Compatible with Supermicro X10DRFF-ITG, X10DRFR, X10DRG-H, X10DRH-C and X10DRFR-T motherboards. It will not work in standard desktop computers or systems that require unbuffered non-ECC memory. Builders needing unregistered DIMMs or consumer DDR4 speeds should look elsewhere.

Registered ECC requirement decides fit

The module is registered ECC DDR4 2400MHz CL17; the system must support registered ECC RDIMMs at this speed and latency. If the platform only accepts unbuffered or non-ECC memory, this part will not function.

Helstu kostir

  • ECC protection prevents data corruption in critical workloads
  • Registered design stabilises signal integrity for dense server configurations
  • 2400 MHz DDR4 speed delivers 19200 MB/s bandwidth for responsive multitasking
  • 16 GB capacity expands memory headroom for virtualisation and large datasets
  • Validated for Supermicro X10DR series motherboards ensuring drop-in compatibility

Tæknilýsing

BrandOWC
Part Number2R4D42R816GB
Capacity16GB
Type288-Pin DDR4 ECC RDIMM
SpeedDDR4 2400 (PC4 19200)
CAS LatencyCL17
Voltage1.2V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx8
Heat SpreaderNo
Compatible SystemSupermicro Motherboard X10DRFF-ITG
Supermicro Motherboard X10DRFR
Supermicro Motherboard X10DRG-H
Supermicro Motherboard X10DRH-C
Supermicro Motherboard X10DRFR-T

Aðrar útgáfur af þessari vöru

5 í viðbót í sama vöruflokki

Sama fjölskylda, mismunandi minni, kælingu eða klukkuhraða — berðu saman áður en þú ákveður þig.

Spurningar um þessa vöru

What slot type and pin count does this 288-pin DDR4 RDIMM require on the Supermicro X10DRFR motherboard?

It installs into a standard 288-pin DDR4 DIMM slot on the listed Supermicro X10 series boards.

Which orientation notch and keying should I align when seating this registered ECC module?

Align the single off-centre notch on the module edge connector with the key in the 288-pin DDR4 slot, then press straight down until both retention clips click.

When should this 16 GB 2Rx8 RDIMM be replaced in a server workload?

Replace the module if system logs show increasing correctable ECC error counts or if a full memory diagnostic reports uncorrectable failures.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.