Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Green circuit board with black memory chips, 260-pin SODIMM form factor, no heat spreader

OWC

OWC 2S1D42R808GB 8GB DDR4 2133 CL15 1.2V 260pin SODIMM HP Envy 27-b100 series

SKU CH-BKDT-9TF52

An 8 GB DDR4 2133 MHz SODIMM module for upgrading HP Envy 27-b100 series all-in-one PCs

  • Capacity8GB
  • Type260-Pin DDR4 Non-ECC SODIMM
  • SpeedDDR4 2133 (PC4 17000)
  • CAS LatencyCL15
  • Voltage1.2V
  • ECCNo
  • Boosts multitasking with 8GB DDR4 2133MHz CL15
  • Runs cooler at 1.2V low-voltage operation
  • Fits HP Envy 27-b100 series via 260-pin SODIMM
  • JEDEC and RoHS compliant for warranty-safe upgrade
  • Easy DIY install with unbuffered non-ECC design

HP Envy 27-b100 compatible DDR4 SODIMM

This 8 GB DDR4 2133 MHz CL15 module is built for the HP Envy 27-b100 series all-in-one desktops. It uses the standard 260-pin SODIMM form factor at 1.2 V and is unbuffered non-ECC. The 2Rx8 rank configuration matches the platform requirements.

Upgrade from lower capacity or slower DDR4

Adding this module increases total memory bandwidth for multitasking and larger datasets. The jump is worthwhile when the system currently runs with 4 GB or 8 GB of slower DDR4, or when free slots exist and the workload demands more simultaneous applications. Buyers needing ECC error correction or registered DIMMs cannot use this product.

Sustained load stability at JEDEC speeds

The module operates at the JEDEC-standard 2133 MHz with CL15 latency and 1.2 V, so thermal output remains predictable during extended sessions. Testing follows JEDEC and RoHS compliance, ensuring consistent throughput without throttling. It is not designed for overclocking or voltages above the rated specification.

Helstu kostir

  • Boosts multitasking with 8GB DDR4 2133MHz CL15
  • Runs cooler at 1.2V low-voltage operation
  • Fits HP Envy 27-b100 series via 260-pin SODIMM
  • JEDEC and RoHS compliant for warranty-safe upgrade
  • Easy DIY install with unbuffered non-ECC design

Tæknilýsing

BrandOWC
Part Number2S1D42R808GB
Capacity8GB
Type260-Pin DDR4 Non-ECC SODIMM
SpeedDDR4 2133 (PC4 17000)
CAS LatencyCL15
Voltage1.2V
ECCNo
Buffered/RegisteredUnbuffered
Rank2Rx8
Heat SpreaderNo
Compatible SystemHP ENVY 27-b100nd
HP ENVY 27-B100NF
HP ENVY 27-b100ng
HP ENVY 27-b100nl
HP ENVY 27-b100no

Aðrar útgáfur af þessari vöru

5 í viðbót í sama vöruflokki

Sama fjölskylda, mismunandi minni, kælingu eða klukkuhraða — berðu saman áður en þú ákveður þig.

Spurningar um þessa vöru

Does the 260-pin DDR4 SODIMM fit the HP Envy 27-b100 series memory slots?

Yes, the 260-pin DDR4 SODIMM form factor matches the slots used in the HP Envy 27-b100nd, 27-B100NF, 27-b100ng, 27-b100nl and 27-b100no models.

What is the correct way to seat the module so it locks in place?

Align the notch on the module with the slot key, insert at a slight angle, then press down firmly until both side clips click into the notches on the PCB.

Will this 1.2 V DDR4 module need any firmware update or voltage adjustment later?

No, the module follows JEDEC standard 1.2 V operation and requires no firmware changes or voltage tweaks for the listed HP Envy systems.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.