Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Green circuit board DDR4 ECC UDIMM 288 pin module

OWC

OWC 8GB DDR4 2666MHz ECC UDIMM CL19 1Rx8 1.2V SA3200D memory upgrade

SKU CH-TGJ2-7PH1C

Adds 8 GB of DDR4 2666 ECC memory to Synology RackStation SA3200D for error-corrected reliability

  • Capacity8GB
  • Type288-Pin DDR4 ECC UDIMM
  • SpeedDDR4 2666 (PC4 21300)
  • CAS LatencyCL19
  • Voltage1.2V
  • ECCYes

Capacity 8GB

  • 8GB capacity expands Synology SA3200D memory for heavier workloads
  • ECC protection detects and corrects single-bit errors automatically
  • DDR4 2666MHz CL19 speed matches system specifications precisely
  • 2V operation reduces power draw and heat output
  • JEDEC and RoHS compliant for warranty-safe installation

OWC 8GB DDR4 ECC UDIMM for Synology SA3200D

This single 8GB module is built for the Synology RackStation SA3200D and other systems that accept 288-pin DDR4 ECC unbuffered DIMMs. It runs at 2666MHz with CL19 latency and 1.2V power draw. The 1Rx8 rank layout fits the memory controller requirements of the target NAS platform.

Sustained-load behaviour

Error-correcting code detects and corrects single-bit errors during continuous operation, reducing silent data corruption in multi-drive arrays. JEDEC-standard timings and ROHS compliance keep the module stable at rated speed without voltage overrides. Backward compatibility with 2133MHz and 2400MHz buses allows the DIMM to clock down automatically when the platform demands it.

Pre-installation checks for NAS memory upgrades

Verify that your SA3200D chassis has a free 288-pin UDIMM slot and that the current firmware supports the total capacity you plan to reach. Confirm the existing modules are also unbuffered ECC DDR4 so ranks and timings remain consistent across channels. The module has no heat spreader, so ensure airflow over the DIMM area is adequate for prolonged workloads.

Helstu kostir

  • 8GB capacity expands Synology SA3200D memory for heavier workloads
  • ECC protection detects and corrects single-bit errors automatically
  • DDR4 2666MHz CL19 speed matches system specifications precisely
  • 2V operation reduces power draw and heat output
  • JEDEC and RoHS compliant for warranty-safe installation

Tæknilýsing

BrandOWC
Part Number2E6D41R808GB
Capacity8GB
Type288-Pin DDR4 ECC UDIMM
SpeedDDR4 2666 (PC4 21300)
CAS LatencyCL19
Voltage1.2V
ECCYes
Buffered/RegisteredUnbuffered
Rank1Rx8
Heat SpreaderNo
Compatible SystemSynology RackstationSA3200D

Aðrar útgáfur af þessari vöru

5 í viðbót í sama vöruflokki

Sama fjölskylda, mismunandi minni, kælingu eða klukkuhraða — berðu saman áður en þú ákveður þig.

Spurningar um þessa vöru

Does the 1.2V DDR4 module run cooler than higher-voltage sticks in a Synology SA3200D running 24/7?

The 1.2V JEDEC-standard voltage keeps power draw low, reducing heat output during continuous operation in the RackStation.

Must the SA3200D already support ECC unbuffered DDR4 for this 288-pin DIMM to function?

Yes, the NAS needs DDR4 ECC unbuffered slots; the module is validated for the SA3200D platform.

Will the 2666MHz CL19 stick downclock automatically if I keep older 2133MHz modules in the same system?

Backward compatibility with 2133MHz and 2400MHz is specified, so the new DIMM will run at the lower speed when mixed.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.