Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Two green DDR4 RDIMM modules with gold contacts and black heat spreaders

RIMLANCE

RIMLANCE RRD25600D8C2K32 32GB (2x16GB) DDR4 3200 ECC Registered RDIMM

SKU CH-0W64-PM3QF

A 32 GB dual-channel DDR4-3200 ECC registered kit built with major-brand DRAM for server workloads

  • Capacity32GB (2 x 16GB)
  • Type288-Pin DDR4 SDRAM
  • SpeedDDR4 3200 (PC4 25600)
  • CAS LatencyCL22
  • ECCYes
  • Buffered/RegisteredRegistered
  • 32 GB dual-channel kit doubles server memory bandwidth
  • DDR4 3200 speed rated at PC4-25600 for fast data throughput
  • ECC registered design corrects errors and reduces electrical load on the memory controller
  • 2Rx8 organisation with major-brand DRAM chips tested for enterprise reliability
  • 2 V operation at CL22 latency balances performance and power efficiency

Capacity & Configuration

This kit provides 32GB of DDR4 server memory in a 2x16GB arrangement. It uses 288-pin RDIMM modules with ECC and registered buffering for error correction and signal integrity. The modules run at 3200MHz with a CAS latency of 22 and operate at 1.2V. It is built for DDR4-compatible servers and workstations that require registered memory.

Suitable Systems & Limitations

This memory suits administrators upgrading or populating DDR4 servers and workstations that support registered ECC RDIMMs. It is not for desktop PCs, laptops or consumer motherboards that accept only unbuffered non-ECC DIMMs. Systems limited to lower DDR4 speeds or those requiring load-reduced or unregistered modules cannot use this kit.

Installation Notes

Installation follows the standard 288-pin RDIMM procedure: power down the server, open the chassis, align the module key with the slot and press firmly until the retention clips engage. The main risk is inserting the kit into a platform that does not support registered ECC memory, which will prevent the system from posting. Always confirm the motherboard qualification list before fitting.

Helstu kostir

  • 32 GB dual-channel kit doubles server memory bandwidth
  • DDR4 3200 speed rated at PC4-25600 for fast data throughput
  • ECC registered design corrects errors and reduces electrical load on the memory controller
  • 2Rx8 organisation with major-brand DRAM chips tested for enterprise reliability
  • 2 V operation at CL22 latency balances performance and power efficiency

Tæknilýsing

BrandRIMLANCE
ModelRRD25600D8C2K32
Capacity32GB (2 x 16GB)
Type288-Pin DDR4 SDRAM
SpeedDDR4 3200 (PC4 25600)
CAS LatencyCL22
ECCYes
Buffered/RegisteredRegistered
Rank2Rx8
ChipsetMajor Brand Chipset

Spurningar um þessa vöru

Does my motherboard need 288-pin DDR4 RDIMM slots to use this 32 GB kit?

Yes, the modules are 288-pin DDR4 SDRAM registered DIMMs and require a server or workstation board with matching RDIMM slots.

Will the 2Rx8 organization of these modules work with older single-rank DDR4 RDIMMs already installed?

Mixing ranks is possible if the platform supports it, but population rules vary by CPU and chipset; consult the system manual for supported rank-per-channel limits.

How can I confirm the kit is running at its rated 3200 MT/s and CL22 after installation?

Check the memory speed and latency in BIOS/UEFI or with a tool such as CPU-Z; both should report DDR4-3200 and CAS latency 22 when the kit operates as specified.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.