Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Four white 120mm case fans with 15 white LEDs each, hydraulic bearing, anti-vibration rubber pads, Molex 4-pin connectors

sakose

sakose 12025-LED 120mm case fan 4-pack 15 LED 1100 RPM 18 dBA

SKU CH-9WC4-CFJCK MPN 12025-LED

Four 120 mm hydraulic-bearing fans with 15 white LEDs each, 1100 RPM and 18 dBA noise

  • ColorWhite
  • LEDWhite

Color White

LED White

Option 4 Heads

  • Four fans included for balanced airflow
  • 15 white LEDs create bright interior lighting
  • Hydraulic bearing runs at 1100 RPM for steady cooling
  • 18 dBA noise level keeps system quiet
  • Anti-vibration rubber pads reduce case resonance

Four-pack 120 mm fans

This four-pack supplies four 120 mm case fans for builders who want matching airflow and lighting across a chassis. Each unit runs at 1100 RPM and is rated at 18 dBA for quiet operation. The hydraulic bearing and nine-blade design aim to balance air volume with low turbulence. White LEDs on every fan create a consistent look inside the case.

Capacity and headroom

At 1100 RPM the fans move enough air for typical mid-range builds and standard radiator thicknesses. Noise stays near 18 dBA, so they suit quiet-focused systems without aggressive curves. Higher static-pressure demands such as dense fin stacks or restrictive filters will exceed their comfort zone. The 12 V Molex power input limits speed control to voltage regulation rather than PWM.

Accessories and software

Anti-vibration rubber pads are included for each fan to reduce chassis resonance during installation. The bundle uses a 4-pin Molex connector, so no motherboard fan header or software utility is required for power. There is no RGB controller, addressable lighting protocol or monitoring application in the package. Builders needing per-fan speed curves or synchronised effects must add their own controller.

Helstu kostir

  • Four fans included for balanced airflow
  • 15 white LEDs create bright interior lighting
  • Hydraulic bearing runs at 1100 RPM for steady cooling
  • 18 dBA noise level keeps system quiet
  • Anti-vibration rubber pads reduce case resonance

Tæknilýsing

BrandSakose
ColorWhite
LEDWhite

Aðrar útgáfur af þessari vöru

5 í viðbót í sama vöruflokki

Sama fjölskylda, mismunandi minni, kælingu eða klukkuhraða — berðu saman áður en þú ákveður þig.

Spurningar um þessa vöru

Will the four 120 mm fans fit in the same mounting points as the older 120 mm fans I already have?

Yes — each fan uses the standard 120 mm frame and the same four-hole pattern, so they drop into existing mounts without modification.

How can I confirm the fans are running at the rated 1100 RPM after I install them?

Check the fan speed in your motherboard BIOS or a monitoring utility; it should read around 1100 RPM with a tolerance of roughly ten percent.

Does the 4-pack include the Molex power cables and the anti-vibration rubber pads, or do I need to buy them separately?

The pack supplies four fans, each with a Molex 4-pin connector attached, plus a set of anti-vibration rubber pads for mounting.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.