Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Two green DDR2 DIMM sticks with gold contacts

Simmtec, Inc

Simmtec, Inc 4GB (2 x 2GB) DDR2 DIMM 240 PIN 667Mhz PC2 5400/5300 TA790GX A2+ memory upgrade

SKU CH-CXZG-30B5B

4GB DDR2 kit (2×2GB) at 667 MHz for Biostar TFORCE TA790GX A2+ boards

  • Capacity4GB (2 x 2GB)
  • 4GB kit (2 × 2GB) doubles system memory for Biostar TA790GX A2+
  • DDR2 667MHz modules run at PC2-5400 or PC2-5300 speeds
  • 240-pin DIMMs install directly into compatible motherboard slots
  • 100% compatible memory validated for the target platform

Biostar TA790GX A2+ DDR2 kit

This 4 GB kit contains two 2 GB DDR2 DIMMs built for the Biostar TFORCE TA790GX A2+ motherboard. Each module uses a 240-pin interface and runs at 667 MHz with PC2-5400 and PC2-5300 ratings. The set is intended for owners of that specific board who need a matched pair to reach the full 4 GB capacity. It is not suited for systems that require a different pin count, voltage or memory generation.

Low-power DDR2 operation

DDR2 modules draw modest power and produce little heat at 667 MHz, so standard case airflow is usually sufficient. No active cooling is included or required for normal desktop workloads. The kit adds minimal load to the motherboard power phases. Buyers who need higher frequencies, lower latencies or larger capacities for overclocking should look elsewhere.

Helstu kostir

  • 4GB kit (2 × 2GB) doubles system memory for Biostar TA790GX A2+
  • DDR2 667MHz modules run at PC2-5400 or PC2-5300 speeds
  • 240-pin DIMMs install directly into compatible motherboard slots
  • 100% compatible memory validated for the target platform

Tæknilýsing

Capacity4GB (2 x 2GB)

Spurningar um þessa vöru

How do I install the two 240-pin DDR2 DIMMs into the Biostar TFORCE TA790GX A2+ and what step is often missed?

Power off the system, open the case, align each module's notch with the slot key, press down firmly until both side clips click, then verify in BIOS that the full 4 GB is recognised at 667 MHz.

What maintenance or replacement will this DDR2 memory kit need over time?

No routine maintenance is required; keep the interior dust-free and reseat the modules only if the system fails to POST, otherwise the kit runs for the life of the motherboard.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.