Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Two green DDR2 DIMM modules with gold contacts in static bag

Simmtec, Inc

Simmtec, Inc MemoryMasters 4GB (2 x 2GB) DDR2 DIMM 240 PIN 800MHz PC2-6400/6300 for DFI LP DK 790GX-M2RS

SKU CH-8KN9-TRDN0

A 4 GB DDR2 kit in two 2 GB modules, 240-pin, rated at 800 MHz PC2-6400/6300, built for the DFI LP DK 790GX-M2RS motherboard

  • Capacity4GB (2 x 2GB)
  • 100% compatible with DFI LANPARTY LP DK 790GX-M2RS motherboard
  • 4GB total capacity delivered as two 2GB DDR2 modules
  • 800MHz DDR2 speed rated at PC2-6400 and PC2-6300
  • 240-pin DIMM form factor for direct desktop installation

DDR2 DIMM kit for DFI LP DK 790GX-M2RS

This 4 GB kit contains two 2 GB DDR2 DIMMs built specifically for the DFI LANPARTY LP DK 790GX-M2RS motherboard. The modules use a 240-pin interface and run at 800 MHz with PC2-6400 and PC2-6300 ratings. They are supplied new and tested for full compatibility with that board.

Upgrade from lower-capacity or slower DDR2 pairs

The kit replaces smaller or slower DDR2 sets installed in the same motherboard. The jump is worthwhile when the system needs the full 4 GB capacity and the rated 800 MHz speed for stability. It does not suit boards that require a different pin count, voltage or memory type.

Helstu kostir

  • 100% compatible with DFI LANPARTY LP DK 790GX-M2RS motherboard
  • 4GB total capacity delivered as two 2GB DDR2 modules
  • 800MHz DDR2 speed rated at PC2-6400 and PC2-6300
  • 240-pin DIMM form factor for direct desktop installation

Tæknilýsing

Capacity4GB (2 x 2GB)

Spurningar um þessa vöru

Will this 240-pin DDR2 DIMM kit fit the DFI LP DK 790GX-M2RS motherboard slots?

The kit is built specifically for the DFI LANPARTY LP DK 790GX-M2RS and uses the standard 240-pin DDR2 DIMM form factor that matches the board's memory sockets.

What is the correct installation sequence for the two 2GB modules on this board?

Install one module in each channel, seating each DIMM firmly until the retention clips click; the common mistake is leaving one clip unlatched, which causes a no-boot condition.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.