Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Two black USB 3.0 to SATA adapter cables for 2.5 inch drives

WRIARICH

WRIARICH USB 3.0 to SATA Adapter for 2.5in Drives, 2-Pack

SKU CH-M4DK-G8FT8

A two-pack of USB 3.0 to SATA adapters connects 2.5-inch drives for data recovery, cloning or extra storage with UASP acceleration up to 70% faster

  • Changer TypeUSB to SATA
  • Connect 2.5" SATA drives externally via USB 3.0
  • Add storage, backup or recover data without an enclosure
  • Reach 5 Gbps speeds, up to 70% faster with UASP
  • Portable, bus-powered design fits in a laptop bag
  • Hot-swap drives instantly with plug-and-play, no drivers needed

USB 3.0 to SATA adapter for 2.5" drives

This two-pack provides USB 3.0 to SATA adapter cables that let you connect a 2.5" SATA hard drive or solid-state drive to a computer through an available USB port. Each adapter supports USB 3.0 data transfer speeds of 5 Gbps and can reach up to 70% faster performance when the host also supports UASP. No external power is required for 2.5" drives, and the plug-and-play design works without driver installation.

Suits laptop upgrades and drive access.

The adapters are built for 2.5" SATA SSDs and HDDs, making them useful for adding external storage to a laptop, performing backups, creating disk images, recovering data, or migrating content between drives. Their portable, cable-only form factor tucks into a laptop bag for on-the-go use. Builders who need to connect 3.5" desktop drives should look at other solutions, as these adapters do not support larger form factors or provide the extra power those drives require.

UASP support on USB 3.0 decides peak speed

The single specification that determines real-world throughput is whether the host system supports UASP over USB 3.0. With UASP enabled, transfer rates can be up to 70% faster than standard USB 3.0 bulk-endpoint operation. If the computer lacks UASP support, the adapter still functions at regular USB 3.0 speeds, but the higher performance ceiling will not be reached.

Helstu kostir

  • Connect 2.5" SATA drives externally via USB 3.0
  • Add storage, backup or recover data without an enclosure
  • Reach 5 Gbps speeds, up to 70% faster with UASP
  • Portable, bus-powered design fits in a laptop bag
  • Hot-swap drives instantly with plug-and-play, no drivers needed

Tæknilýsing

ModelFor 2.5in SATA drives
Changer TypeUSB to SATA

Spurningar um þessa vöru

Does the USB 3.0 to SATA adapter need a separate power supply to run a 2.5" SSD?

No, the adapter draws power from the USB port and works with 2.5" SSDs or HDDs without any external power brick.

Will the adapter work with a laptop that only has USB 2.0 ports?

Yes, it is backward compatible with USB 2.0, though transfer speeds will be limited to USB 2.0 rates instead of the 5 Gbps USB 3.0 maximum.

How can I verify the adapter is using UASP for faster transfers after I plug it in?

In Windows Device Manager check the drive's properties; if the driver shows "UASPStor" or similar UASP support, the protocol is active and you should see speeds up to 70% faster than standard USB 3.0.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.