Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Zyvpee 70mm black case fan 7015 4 pin

Zyvpee

Zyvpee DA07015R12U P064 70mm 4 Pin Case Fan

SKU CH-DARS-N154K

A 70mm case fan with ball bearing, 12V 0.7A power and a 4-pin connector for CPU cooler compatibility

  • TypeCase Fan
  • CompatibilityCPU Cooler
  • Bearing TypeBall
  • Power Connector4 Pin
  • ColorBlack
  • LEDNon-LED
  • 70 mm frame fits tight CPU cooler builds
  • 12 V 0.7 A draw keeps power use low
  • four-pin connector enables PWM speed control
  • ball bearing design extends operating life
  • non-LED black finish suits any system aesthetic

70mm 4-pin CPU cooler fan

The Zyvpee DA07015R12U is a 70 by 15 millimetre case fan built for CPU cooler mounting. It runs on 12 volts and draws point seven amps through a standard four-pin power connector. The ball bearing design targets users who need reliable airflow in tight cooler assemblies. Non-LED black finish keeps the look neutral inside any chassis.

Ball bearing and four-wire control

A ball bearing motor provides consistent rotation for long-term cooling duty. The four-wire connector enables pulse-width modulation speed control from a motherboard header. Black frame and blades blend with most builds while the compact 7015 form factor fits slim tower coolers. DC operation means voltage regulation is handled by the board, not the fan itself.

Check cooler mounting and header type

Verify that your CPU cooler accepts a 70 by 15 millimetre fan before ordering. Confirm the motherboard has a four-pin fan header available for PWM control. This unit is not suited for builds requiring LED illumination or larger frame sizes. Buyers needing higher static pressure or different voltage specs should look elsewhere.

Helstu kostir

  • 70 mm frame fits tight CPU cooler builds
  • 12 V 0.7 A draw keeps power use low
  • four-pin connector enables PWM speed control
  • ball bearing design extends operating life
  • non-LED black finish suits any system aesthetic

Tæknilýsing

BrandZyvpee
SeriesDA07015R12U
ModelDA07015R12U
TypeCase Fan
CompatibilityCPU Cooler
Bearing TypeBall
Power Connector4 Pin
ColorBlack
LEDNon-LED
FeaturesDC Case Fan
Dimensions70*15mm

Spurningar um þessa vöru

Does the 4 pin connector on this 70 mm fan use PWM control or only voltage regulation?

The four wire connector carries a PWM signal so the motherboard can vary speed precisely rather than relying on voltage drops alone.

What mounting hole spacing does the 70 by 15 mm frame require?

Standard 70 mm square pattern with holes centred roughly 64 mm apart fits typical CPU cooler brackets.

How do you orient the fan when screwing it onto a heatsink so airflow goes the right way?

Match the arrow on the frame to exhaust direction; the label side usually faces out and the wire exits toward the rear.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.