Priimame kriptovaliutą — taip monetos, kurias turite, gali nupirkti tikrą techniką.Mokėkite kriptovaliuta, išleiskite ją tikrai technikai. Nemokamas apdraustas pristatymas visame pasaulyje virš 399 $. Paprastos, be žymų siuntos dėžės, siunčiamos iš Vokietijos.Nemokamas apdraustas pristatymas virš 399 $. Jūsų kursas fiksuojamas 30 minučių, kai tik prasideda atsiskaitymas.Kursas fiksuojamas 30 minučių. Kiekvienas gaminys užplombuotas, jo serijos numeris patikrintas, ir jam taikoma 24 mėnesių garantija.Užplombuota, 24 mėnesių garantija.

Stebimos prekės Prisijungti
Green circuit board with silver heatsinks and soldered components

KHACHIMO

KHACHIMO T-pro2 Power Amplifier Board 500W+150W

SKU CH-HRSQ-5JXKT

Delivers 500W bass and 150W treble through a D-class amplifier module

  • TypeATX
  • Digital D-Class module delivers 500 W bass and 150 W treble
  • Tested working before shipment for reliable operation
  • Good-quality components support stable amplifier performance
  • ATX form factor fits standard power-supply mounting

Power Amplifier Board for Pascal T-pro2

This D-Class power amplifier module is built for the Pascal T-pro2 system and delivers dedicated bass and treble amplification in a single board. It suits audio builders who need a tested, ready-to-install module for a two-channel speaker project. The unit arrives new and verified working.

Output Power Bass 500W Treble 150W

The module provides 500 W for the bass channel at 4 ohms and 150 W for the treble channel at 8 ohms, giving ample headroom for typical home or PA speakers. It will run out of clean power if the load drops below the rated impedance or if sustained peaks exceed the rated output.

Privalumai

  • Digital D-Class module delivers 500 W bass and 150 W treble
  • Tested working before shipment for reliable operation
  • Good-quality components support stable amplifier performance
  • ATX form factor fits standard power-supply mounting

Specifikacijos

TypeATX

Klausimai apie šią prekę

Can the 500 W bass channel and 150 W treble channel operate together from my existing ATX supply?

The module is an ATX-type board rated for 500 W on the bass output and 150 W on the treble output, so both channels draw power from the same ATX source.

How do I verify the amplifier is delivering its rated output after installation?

Play a test tone and measure the speaker terminals; you should see the expected voltage swing for 500 W into 4 Ω on the bass channel and 150 W into 8 Ω on the treble channel.

Taip pat šiame skyriuje

Kiti pirkėjai taip pat lygino

Ta pati lentyna, tas pats atsiskaitymas — aštuonios monetos ir 30 minučių fiksuotas kursas.