Acceptăm criptomonede — astfel, criptomonedele pe care le dețineți pot cumpăra echipamente reale.Plătiți în cripto, cheltuiți-o pe echipamente reale. Livrare asigurată gratuită oriunde în lume peste 399 $. Cartoane neutre, fără marcă, expediate din Germania.Livrare asigurată gratuită peste 399 $. Cursul dumneavoastră este blocat timp de 30 de minute de la deschiderea paginii de plată.Curs blocat 30 de minute. Fiecare articol este sigilat, numărul de serie este verificat, iar produsul este acoperit de o garanție de 24 de luni.Sigilat, garantat 24 de luni.

Produse urmărite Conectare
Green circuit board with silver heatsinks and soldered components

KHACHIMO

KHACHIMO T-pro2 Power Amplifier Board 500W+150W

SKU CH-HRSQ-5JXKT

Delivers 500W bass and 150W treble through a D-class amplifier module

  • TypeATX
  • Digital D-Class module delivers 500 W bass and 150 W treble
  • Tested working before shipment for reliable operation
  • Good-quality components support stable amplifier performance
  • ATX form factor fits standard power-supply mounting

Power Amplifier Board for Pascal T-pro2

This D-Class power amplifier module is built for the Pascal T-pro2 system and delivers dedicated bass and treble amplification in a single board. It suits audio builders who need a tested, ready-to-install module for a two-channel speaker project. The unit arrives new and verified working.

Output Power Bass 500W Treble 150W

The module provides 500 W for the bass channel at 4 ohms and 150 W for the treble channel at 8 ohms, giving ample headroom for typical home or PA speakers. It will run out of clean power if the load drops below the rated impedance or if sustained peaks exceed the rated output.

Puncte forte

  • Digital D-Class module delivers 500 W bass and 150 W treble
  • Tested working before shipment for reliable operation
  • Good-quality components support stable amplifier performance
  • ATX form factor fits standard power-supply mounting

Specificații

TypeATX

Întrebări despre acest articol

Can the 500 W bass channel and 150 W treble channel operate together from my existing ATX supply?

The module is an ATX-type board rated for 500 W on the bass output and 150 W on the treble output, so both channels draw power from the same ATX source.

How do I verify the amplifier is delivering its rated output after installation?

Play a test tone and measure the speaker terminals; you should see the expected voltage swing for 500 W into 4 Ω on the bass channel and 150 W into 8 Ω on the treble channel.

Tot din acest raion

Clienții au comparat și acestea.

Același raion, aceeași finalizare a comenzii — opt monede și un curs blocat 30 de minute.