SanDisk
SanDisk Cruzer Blade 8 GB USB 2.0 USB flash drive Black SDCZ50-008G-B35
391,99 $
0.00501831BTC
Krājumā
A-Tech
A-Tech 4GB DDR3 1333MHz PC3-10600 240-Pin DIMM desktop RAM
A 4 GB DDR3 desktop module running at 1333 MHz with CL9 timing and 1.5 V operation
- Capacity4GB
- SpeedDDR3 1333 (PC3 10600)
- Tested Frequency1333
- CAS LatencyCL9
- Voltage1.50V
- ECCNo
- 4GB capacity adds headroom for everyday multitasking
- 1333 MHz DDR3 speed matches PC3-10600 spec
- CL9 latency at 1.5 V standard voltage
- 240-pin unbuffered DIMM fits desktop slots
- Tested replacement for HP part 497158-B88
Compatible DDR3 Upgrade
This 4 GB DDR3 module runs at 1333 MHz with PC3-10600 timing and CL9 latency. It is an unbuffered non-ECC DIMM designed for desktop systems and serves as a direct replacement for HP part 497158-B88.
240-Pin Standard DIMM
The stick uses the 240-pin DDR3 form factor and operates at the standard 1.5 V, so it fits any desktop slot wired for DDR3 without adapters. Major-brand chips are used throughout and every unit undergoes quality-assurance testing before shipment.
Low-Voltage Efficiency
At 1.50 V the module draws only the power defined by the DDR3 specification, keeping heat output modest and fan noise unchanged during typical desktop workloads. The standard voltage also ensures broad compatibility with AMD and Intel platforms that support DDR3 memory.
Priekšrocības
- 4GB capacity adds headroom for everyday multitasking
- 1333 MHz DDR3 speed matches PC3-10600 spec
- CL9 latency at 1.5 V standard voltage
- 240-pin unbuffered DIMM fits desktop slots
- Tested replacement for HP part 497158-B88
Specifikācijas
| Brand | A-Tech |
|---|---|
| Capacity | 4GB |
| Speed | DDR3 1333 (PC3 10600) |
| Tested Frequency | 1333 |
| CAS Latency | CL9 |
| Voltage | 1.50V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Chipset | Major Brand Chips |
| Features | Major Brand Chipset |
| Recommend Use | AMD & Intel Compatible |
Jautājumi par šo preci
Will this 240-pin DDR3 DIMM fit my HP desktop that originally used part 497158-B88?
Yes — the module is listed as a compatible equivalent for HP 497158-B88 and uses the same 240-pin DDR3 form factor.
My motherboard only supports 1.5 V DDR3; is this kit within that limit?
The DIMM runs at the standard 1.50 V DDR3 voltage, matching the 1.5 V requirement.
I need a single 4 GB stick for a dual-channel board; will this work?
This is a single 4 GB module (1 x 4 GB) and is unbuffered non-ECC, so it can populate one slot of a dual-channel desktop board.
Arī šajā sadaļā
Klienti arī salīdzināja
Tas pats plaukts, tā pati kase — astoņas kriptovalūtas un kursa fiksēšana uz 30 minūtēm.
