SanDisk
SanDisk Cruzer Blade 8 GB USB 2.0 USB flash drive Black SDCZ50-008G-B35
391,99 $
0.00496668BTC
Krājumā
Brute Networks
Brute Networks HPE Compatible 8GB DDR4-2933 1Rx8 1.2V 288-Pin Server RAM
8GB DDR4-2933 registered ECC server memory with 1Rx8 organisation and 1.2V operation
- Capacity8GB
- Type288-Pin DDR4 SDRAM
- SpeedDDR4 2933 (PC4 23400)
- Voltage1.20V
- ECCYes
- Buffered/RegisteredRegistered
- HPE compatible upgrade fits existing server infrastructure
- DDR4-2933 speed delivers 23400 MT/s data throughput
- Registered ECC design protects data integrity
- 20 V operation reduces power consumption
- Major-brand Samsung, SK Hynix or Micron chips ensure reliability
HPE-compatible 8GB DDR4-2933 module
This 8GB registered ECC DDR4-2933 DIMM is built for HPE servers that require PC4-23400 memory. It targets IT teams extending the life of existing infrastructure without paying OEM list prices.
8GB single-rank capacity and headroom
The single 1Rx8 rank delivers 8GB at 1.20V, suited to standard multi-socket configurations. Workloads needing larger per-slot density or higher frequencies will exceed this module's limits.
Registered ECC thermals and power
Registered buffering and on-die ECC add minimal latency while stabilising signal integrity under load. The 1.20V operating voltage keeps power draw low in dense server chassis, and the major-brand DRAM maintains consistent thermals during sustained operation.
Priekšrocības
- HPE compatible upgrade fits existing server infrastructure
- DDR4-2933 speed delivers 23400 MT/s data throughput
- Registered ECC design protects data integrity
- 20 V operation reduces power consumption
- Major-brand Samsung, SK Hynix or Micron chips ensure reliability
Specifikācijas
| Brand | HPE |
|---|---|
| Capacity | 8GB |
| Type | 288-Pin DDR4 SDRAM |
| Speed | DDR4 2933 (PC4 23400) |
| Voltage | 1.20V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 1Rx8 |
| Chipset | Major Brand Chipset |
Jautājumi par šo preci
Will this 8GB DDR4-2933 registered ECC module operate alongside existing DDR4 modules in my HPE server?
The module runs at DDR4-2933 (PC4-23400) with 1.20 V, registered ECC, 1Rx8 organisation and 288-pin form factor; when mixed, all DIMMs will run at the speed of the slowest installed module.
How can I confirm the module is recognised and running at the correct speed after installation?
Check the server BIOS or iLO interface — it should show 8 GB, DDR4-2933, registered ECC, 1Rx8 and 1.20 V for the new DIMM.
What ships with the module and is anything else required for installation?
Only the 288-pin DDR4 SDRAM module is supplied; no extra cables, brackets or software are needed — just an available DDR4 DIMM slot.
Arī šajā sadaļā
Klienti arī salīdzināja
Tas pats plaukts, tā pati kase — astoņas kriptovalūtas un kursa fiksēšana uz 30 minūtēm.
