Mēs pieņemam kriptovalūtu — lai tā, kas Jums pieder, varētu nopirkt īstu aparatūru.Maksājiet kriptovalūtā, iztērējiet to īstai aparatūrai. Bezmaksas apdrošināta piegāde visā pasaulē virs 399 $. Vienkāršas, nemarķētas kastes, sūtītas no Vācijas.Bezmaksas apdrošināta piegāde virs 399 $. Jūsu kurss tiek fiksēts uz 30 minūtēm, tiklīdz atveras kase.Kurss fiksēts uz 30 minūtēm. Katra prece ir aizzīmogota, tās sērijas numurs ir pārbaudīts, un uz to attiecas 24 mēnešu garantija.Aizzīmogots, 24 mēnešu garantija.

Uzraudzītās preces Pieteikties
Two green DDR3 SO-DIMM sticks with black chips, no heat spreader

Computer Memory Solutions

Computer Memory Solutions CM512648500DIMMDR 8GB (2x4GB) DDR3 1066MHz SO-DIMM memory upgrade

SKU CH-BKAY-HBTE8

8GB DDR3 1066MHz SO-DIMM kit with two 4GB unbuffered modules at CL7 timing for compatible Gigabyte motherboards

  • Capacity8GB (2 x 4GB)
  • Type204-Pin DDR3 SO-DIMM
  • SpeedDDR3 1066 (PC3 8500)
  • CAS LatencyCL7
  • Timing7-7-7
  • Voltage1.5V
  • 8 GB total capacity from two 4 GB modules
  • DDR3 1066 MHz speed rated at PC3 8500
  • CL7 latency with 7-7-7 timings for responsive operation
  • 5 V unbuffered non-ECC design matches system requirements
  • Tested compatible with Gigabyte GA-MA770 series motherboards

Compatible 8GB DDR3 kit

This 8GB kit contains two 4GB DDR3 SO-DIMM modules rated at 1066 MHz with CL7 timings. It is validated for the Gigabyte GA-MA770T-UD3, GA-MA770T-UD3P and GA-MA770T-US3 motherboards. Builders upgrading those specific boards can install this pair with confidence.

Low-voltage unbuffered operation

Each module runs at the standard 1.5 V without a heat spreader, drawing minimal power during typical desktop workloads. The unbuffered, non-ECC design keeps electrical load light on the memory controller. Silent, passive cooling is sufficient for everyday use.

Steady throughput under load

The matched 2Rx8 sticks maintain their 7-7-7 timings during extended sessions, avoiding the throttling that mismatched pairs can trigger. Systems limited to 16 GB maximum capacity will recognise the full 8 GB when a 64-bit operating system is used. Mixing with ECC modules is not recommended.

Priekšrocības

  • 8 GB total capacity from two 4 GB modules
  • DDR3 1066 MHz speed rated at PC3 8500
  • CL7 latency with 7-7-7 timings for responsive operation
  • 5 V unbuffered non-ECC design matches system requirements
  • Tested compatible with Gigabyte GA-MA770 series motherboards

Specifikācijas

BrandComputer Memory Solutions
ModelCM512648500DIMMDR
Capacity8GB (2 x 4GB)
Type204-Pin DDR3 SO-DIMM
SpeedDDR3 1066 (PC3 8500)
CAS LatencyCL7
Timing7-7-7
Voltage1.5V
ECCNo
Buffered/RegisteredUnbuffered
Rank2Rx8
ChipsetMajor Brand Chipset
Heat SpreaderNo
Compatible SystemGigabyte Ga-Ma770T-Ud3, Ga-Ma770T-Ud3P, Ga-Ma770T-Us3
Package Content2 Memory RAM Sticks

Jautājumi par šo preci

How do I install these 204-pin DDR3 SO-DIMM modules into the Gigabyte GA-MA770T-UD3 and what step is often missed?

Align the notch on each 204-pin DDR3 SO-DIMM with the slot key, press firmly until both side clips click shut, then verify in BIOS that both 4 GB modules are detected at 1066 MHz.

What maintenance or replacement will this 8 GB kit need over time?

No scheduled maintenance is required; if a module fails it is covered by the manufacturer's limited lifetime warranty and can be replaced with an identical 204-pin DDR3 1066 MHz SO-DIMM.

What limit appears first when running this memory at full load for extended periods?

The motherboard's maximum supported capacity of 16 GB across four sockets is the first hard limit; sustained throughput is capped by the DDR3 1066 MHz (PC3 8500) specification.

Arī šajā sadaļā

Klienti arī salīdzināja

Tas pats plaukts, tā pati kase — astoņas kriptovalūtas un kursa fiksēšana uz 30 minūtēm.