Wij accepteren cryptovaluta — zo kunnen de munten die u bezit echte hardware kopen.Betaal in crypto, besteed het aan echte hardware. Gratis verzekerde verzending wereldwijd vanaf $399. Neutrale dozen zonder merk, verzonden vanuit Duitsland.Gratis verzekerde verzending vanaf $399. Uw koers wordt 30 minuten vastgezet zodra het afrekenen begint.Koers 30 minuten vastgezet. Elk artikel is verzegeld, het serienummer wordt gecontroleerd, en het valt onder 24 maanden garantie.Verzegeld, 24 maanden garantie.

Favoriete artikelen Inloggen

Computer Memory Solutions

Computer Memory Solutions CM512648500DIMMDR 8GB (2x4GB) DDR3 1066MHz SO-DIMM memory upgrade

SKU CH-BKAY-HBTE8

8GB DDR3 1066MHz SO-DIMM kit with two 4GB unbuffered modules at CL7 timing for compatible Gigabyte motherboards

  • Capacity8GB (2 x 4GB)
  • Type204-Pin DDR3 SO-DIMM
  • SpeedDDR3 1066 (PC3 8500)
  • CAS LatencyCL7
  • Timing7-7-7
  • Voltage1.5V
  • 8 GB total capacity from two 4 GB modules
  • DDR3 1066 MHz speed rated at PC3 8500
  • CL7 latency with 7-7-7 timings for responsive operation
  • 5 V unbuffered non-ECC design matches system requirements
  • Tested compatible with Gigabyte GA-MA770 series motherboards

Compatible 8GB DDR3 kit

This 8GB kit contains two 4GB DDR3 SO-DIMM modules rated at 1066 MHz with CL7 timings. It is validated for the Gigabyte GA-MA770T-UD3, GA-MA770T-UD3P and GA-MA770T-US3 motherboards. Builders upgrading those specific boards can install this pair with confidence.

Low-voltage unbuffered operation

Each module runs at the standard 1.5 V without a heat spreader, drawing minimal power during typical desktop workloads. The unbuffered, non-ECC design keeps electrical load light on the memory controller. Silent, passive cooling is sufficient for everyday use.

Steady throughput under load

The matched 2Rx8 sticks maintain their 7-7-7 timings during extended sessions, avoiding the throttling that mismatched pairs can trigger. Systems limited to 16 GB maximum capacity will recognise the full 8 GB when a 64-bit operating system is used. Mixing with ECC modules is not recommended.

Pluspunten

  • 8 GB total capacity from two 4 GB modules
  • DDR3 1066 MHz speed rated at PC3 8500
  • CL7 latency with 7-7-7 timings for responsive operation
  • 5 V unbuffered non-ECC design matches system requirements
  • Tested compatible with Gigabyte GA-MA770 series motherboards

Specificaties

BrandComputer Memory Solutions
ModelCM512648500DIMMDR
Capacity8GB (2 x 4GB)
Type204-Pin DDR3 SO-DIMM
SpeedDDR3 1066 (PC3 8500)
CAS LatencyCL7
Timing7-7-7
Voltage1.5V
ECCNo
Buffered/RegisteredUnbuffered
Rank2Rx8
ChipsetMajor Brand Chipset
Heat SpreaderNo
Compatible SystemGigabyte Ga-Ma770T-Ud3, Ga-Ma770T-Ud3P, Ga-Ma770T-Us3
Package Content2 Memory RAM Sticks

Vragen over dit artikel

How do I install these 204-pin DDR3 SO-DIMM modules into the Gigabyte GA-MA770T-UD3 and what step is often missed?

Align the notch on each 204-pin DDR3 SO-DIMM with the slot key, press firmly until both side clips click shut, then verify in BIOS that both 4 GB modules are detected at 1066 MHz.

What maintenance or replacement will this 8 GB kit need over time?

No scheduled maintenance is required; if a module fails it is covered by the manufacturer's limited lifetime warranty and can be replaced with an identical 204-pin DDR3 1066 MHz SO-DIMM.

What limit appears first when running this memory at full load for extended periods?

The motherboard's maximum supported capacity of 16 GB across four sockets is the first hard limit; sustained throughput is capped by the DDR3 1066 MHz (PC3 8500) specification.

Ook in deze afdeling

Klanten vergeleken ook

Dezelfde afdeling, dezelfde kassa — acht munten en een koers die 30 minuten vaststaat.