Mēs pieņemam kriptovalūtu — lai tā, kas Jums pieder, varētu nopirkt īstu aparatūru.Maksājiet kriptovalūtā, iztērējiet to īstai aparatūrai. Bezmaksas apdrošināta piegāde visā pasaulē virs 399 $. Vienkāršas, nemarķētas kastes, sūtītas no Vācijas.Bezmaksas apdrošināta piegāde virs 399 $. Jūsu kurss tiek fiksēts uz 30 minūtēm, tiklīdz atveras kase.Kurss fiksēts uz 30 minūtēm. Katra prece ir aizzīmogota, tās sērijas numurs ir pārbaudīts, un uz to attiecas 24 mēnešu garantija.Aizzīmogots, 24 mēnešu garantija.

Uzraudzītās preces Pieteikties
Rectangular 1650 W ATX power supply, matte black finish, 135 mm fan grille, fully modular cable sockets

FSP

FSP MEGA TI 1650W power supply

SKU CH-62CG-1ABJP

Delivers 1650 W with 80 PLUS and Cybenetics Titanium efficiency, ATX 3.1 and PCIe 5.1 support, two native 12V-2x6 connectors, 10 SATA connectors, a 135 mm FDB fan with Zero-RPM mode.

  • TypeATX 3.1 Compatible
  • Maximum Power1650 W
  • SLISLI Ready
  • CrossFireCrossFire Ready
  • ModularFull Modular
  • Fans1 x 135 mm
  • 80 PLUS and Cybenetics Titanium efficiency keeps power loss below 6%
  • ATX 3.1 compliance allows up to 200% power excursion for modern GPUs
  • Two native 12V-2x6 plus six 6+2-pin connectors support multi-GPU configurations
  • Cybenetics Lambda A++ rating with 135 mm FDB fan and Zero-RPM mode
  • Conformal coating protects internals up to 95% relative humidity

High-wattage ATX 3.1 power supply

The FSP MEGA TI 1650W is a fully modular ATX 3.1 unit rated for 1650 W continuous output. It carries 80 PLUS Titanium and Cybenetics Titanium efficiency certifications plus a Cybenetics Lambda A++ noise rating. Two native 12V-2x6 connectors and six 6+2-pin PCIe plugs support multi-GPU configurations. The compact 180 mm depth helps it fit space-constrained builds.

Straightforward modular install with one cable trap

All cables detach, so only the required leads go into the case. The 135 mm FDB fan includes a zero-RPM mode that stays off at low load. Conformal coating on the PCB adds resistance to dust and humidity up to 95 % relative humidity. The main 20+4-pin cable reaches 650 mm; PCIe cables are 700 mm, and the ten SATA connectors share a 965 mm total run — check routing in very large chassis.

Best for multi-GPU workstations.

Enthusiasts running dual high-end graphics cards or compute accelerators will use the headroom and 200 % excursion capability. The single +12 V rail and full protection set (OVP, UVP, OPP, SCP, OCP, OTP) suit heavy sustained loads. Single-GPU gamers or modest workstations gain no benefit from this class of unit and should consider lower-wattage Titanium models instead.

Priekšrocības

  • 80 PLUS and Cybenetics Titanium efficiency keeps power loss below 6%
  • ATX 3.1 compliance allows up to 200% power excursion for modern GPUs
  • Two native 12V-2x6 plus six 6+2-pin connectors support multi-GPU configurations
  • Cybenetics Lambda A++ rating with 135 mm FDB fan and Zero-RPM mode
  • Conformal coating protects internals up to 95% relative humidity

Specifikācijas

BrandFSP Group
ModelMEGA TI 1650W
SeriesMEGA TI Series
Part NumberPPA16F0207
TypeATX 3.1 Compatible
Maximum Power1650 W
SLISLI Ready
CrossFireCrossFire Ready
ModularFull Modular
Fans1 x 135 mm
PFCActive
Main Connector20+4Pin
+12V RailsSingle
PCI-Express Connector6 × 6+2 Pin (650 mm), 2 × 12V-2x6 (700 mm)
SATA Power Connector10 × SATA (965 mm total length)
Power Good Signal100-500ms
Hold-up Time> 17 ms at 80% load
Efficiency≥ 94% (80 PLUS Titanium Certified)
Energy-Efficient80 PLUS TITANIUM Certified
PSU Noise LevelCybenetics A++

Jautājumi par šo preci

How can I verify the MEGA TI 1650W is running correctly after installation?

The unit is 80 PLUS and Cybenetics Titanium certified with ≥ 94% efficiency and Lambda A++ noise rating. A Power Good signal of 100-500ms and hold-up time > 17 ms at 80% load confirm stable delivery.

What cables come in the box and what must I source separately for the MEGA TI 1650W?

Included are 6 × 6+2 Pin PCIe cables at 650 mm, 2 × native 12V-2x6 cables at 700 mm, 10 SATA connectors across 965 mm total length, and a 20+4 Pin main connector. No extra cables are required for standard builds.

Which MEGA TI capacity should I choose for a dual-GPU system with heavy overclocking?

The 1650 W single-rail design with 200% excursion support and 2 × 12V-2x6 plus 6 × 6+2 Pin connectors is built for dual high-end GPUs and extreme loads.

Arī šajā sadaļā

Klienti arī salīdzināja

Tas pats plaukts, tā pati kase — astoņas kriptovalūtas un kursa fiksēšana uz 30 minūtēm.