Aceitamos criptomoeda — para que as moedas que detém possam comprar material informático real.Pague em cripto, gaste-a em material informático real. Envio seguro gratuito para todo o mundo acima de 399 $. Caixas neutras, sem marca, expedidas a partir da Alemanha.Envio seguro gratuito acima de 399 $. A sua taxa fica bloqueada durante 30 minutos assim que abre a finalização da compra.Taxa bloqueada 30 minutos. Cada artigo é selado, o seu número de série é verificado, e está coberto por uma garantia de 24 meses.Selado, garantido 24 meses.

Artigos guardados Iniciar sessão
Rectangular 1650 W ATX power supply, matte black finish, 135 mm fan grille, fully modular cable sockets

FSP

FSP MEGA TI 1650W power supply

SKU CH-62CG-1ABJP

Delivers 1650 W with 80 PLUS and Cybenetics Titanium efficiency, ATX 3.1 and PCIe 5.1 support, two native 12V-2x6 connectors, 10 SATA connectors, a 135 mm FDB fan with Zero-RPM mode.

  • TypeATX 3.1 Compatible
  • Maximum Power1650 W
  • SLISLI Ready
  • CrossFireCrossFire Ready
  • ModularFull Modular
  • Fans1 x 135 mm
  • 80 PLUS and Cybenetics Titanium efficiency keeps power loss below 6%
  • ATX 3.1 compliance allows up to 200% power excursion for modern GPUs
  • Two native 12V-2x6 plus six 6+2-pin connectors support multi-GPU configurations
  • Cybenetics Lambda A++ rating with 135 mm FDB fan and Zero-RPM mode
  • Conformal coating protects internals up to 95% relative humidity

High-wattage ATX 3.1 power supply

The FSP MEGA TI 1650W is a fully modular ATX 3.1 unit rated for 1650 W continuous output. It carries 80 PLUS Titanium and Cybenetics Titanium efficiency certifications plus a Cybenetics Lambda A++ noise rating. Two native 12V-2x6 connectors and six 6+2-pin PCIe plugs support multi-GPU configurations. The compact 180 mm depth helps it fit space-constrained builds.

Straightforward modular install with one cable trap

All cables detach, so only the required leads go into the case. The 135 mm FDB fan includes a zero-RPM mode that stays off at low load. Conformal coating on the PCB adds resistance to dust and humidity up to 95 % relative humidity. The main 20+4-pin cable reaches 650 mm; PCIe cables are 700 mm, and the ten SATA connectors share a 965 mm total run — check routing in very large chassis.

Best for multi-GPU workstations.

Enthusiasts running dual high-end graphics cards or compute accelerators will use the headroom and 200 % excursion capability. The single +12 V rail and full protection set (OVP, UVP, OPP, SCP, OCP, OTP) suit heavy sustained loads. Single-GPU gamers or modest workstations gain no benefit from this class of unit and should consider lower-wattage Titanium models instead.

Pontos fortes

  • 80 PLUS and Cybenetics Titanium efficiency keeps power loss below 6%
  • ATX 3.1 compliance allows up to 200% power excursion for modern GPUs
  • Two native 12V-2x6 plus six 6+2-pin connectors support multi-GPU configurations
  • Cybenetics Lambda A++ rating with 135 mm FDB fan and Zero-RPM mode
  • Conformal coating protects internals up to 95% relative humidity

Especificações

BrandFSP Group
ModelMEGA TI 1650W
SeriesMEGA TI Series
Part NumberPPA16F0207
TypeATX 3.1 Compatible
Maximum Power1650 W
SLISLI Ready
CrossFireCrossFire Ready
ModularFull Modular
Fans1 x 135 mm
PFCActive
Main Connector20+4Pin
+12V RailsSingle
PCI-Express Connector6 × 6+2 Pin (650 mm), 2 × 12V-2x6 (700 mm)
SATA Power Connector10 × SATA (965 mm total length)
Power Good Signal100-500ms
Hold-up Time> 17 ms at 80% load
Efficiency≥ 94% (80 PLUS Titanium Certified)
Energy-Efficient80 PLUS TITANIUM Certified
PSU Noise LevelCybenetics A++

Perguntas sobre este artigo

How can I verify the MEGA TI 1650W is running correctly after installation?

The unit is 80 PLUS and Cybenetics Titanium certified with ≥ 94% efficiency and Lambda A++ noise rating. A Power Good signal of 100-500ms and hold-up time > 17 ms at 80% load confirm stable delivery.

What cables come in the box and what must I source separately for the MEGA TI 1650W?

Included are 6 × 6+2 Pin PCIe cables at 650 mm, 2 × native 12V-2x6 cables at 700 mm, 10 SATA connectors across 965 mm total length, and a 20+4 Pin main connector. No extra cables are required for standard builds.

Which MEGA TI capacity should I choose for a dual-GPU system with heavy overclocking?

The 1650 W single-rail design with 200% excursion support and 2 × 12V-2x6 plus 6 × 6+2 Pin connectors is built for dual high-end GPUs and extreme loads.

Também nesta secção

Os clientes também compararam

Mesma prateleira, mesma finalização da compra — oito moedas e uma taxa bloqueada durante 30 minutos.