Mēs pieņemam kriptovalūtu — lai tā, kas Jums pieder, varētu nopirkt īstu aparatūru.Maksājiet kriptovalūtā, iztērējiet to īstai aparatūrai. Bezmaksas apdrošināta piegāde visā pasaulē virs 399 $. Vienkāršas, nemarķētas kastes, sūtītas no Vācijas.Bezmaksas apdrošināta piegāde virs 399 $. Jūsu kurss tiek fiksēts uz 30 minūtēm, tiklīdz atveras kase.Kurss fiksēts uz 30 minūtēm. Katra prece ir aizzīmogota, tās sērijas numurs ir pārbaudīts, un uz to attiecas 24 mēnešu garantija.Aizzīmogots, 24 mēnešu garantija.

Uzraudzītās preces Pieteikties
Green rectangular driver board with HDMI and USB connectors beside a 7 inch LCD panel

Hetai Tech

Hetai Tech 7 inch 1024*600 EJ070NA-01J LCD Driver Board

SKU CH-ATYB-KF5KD

A 7-inch driver board with 1024×600 resolution and 5-wire resistive touchscreen for Raspberry Pi and other mini computers

  • Monitor TypeTouchscreen Monitor
  • Touchscreen Type5-wire Resistive
  • Screen Size15"
  • 7 inch 1024*600 resolution for sharp visuals
  • 5-wire resistive touchscreen enables precise input
  • Compatible with Raspberry Pi B+ 2 3 and Banana/Orange Pi
  • Good quality driver board ensures reliable operation

7 inch 1024*600 LCD driver board

This 7 inch 1024*600 EJ070NA-01J LCD driver board drives a 15 inch touchscreen monitor with a 5-wire resistive panel. It is built for makers connecting a display to Raspberry Pi or Banana/Orange Pi mini computers. The board is supplied new and intended for IoT edge and development projects.

Thermals noise and power

The board draws low power in normal operation and runs silently without active cooling. Heat output is minimal during typical display use. No fan or radiator is required for standard workloads.

Priekšrocības

  • 7 inch 1024*600 resolution for sharp visuals
  • 5-wire resistive touchscreen enables precise input
  • Compatible with Raspberry Pi B+ 2 3 and Banana/Orange Pi
  • Good quality driver board ensures reliable operation

Specifikācijas

Monitor TypeTouchscreen Monitor
Touchscreen Type5-wire Resistive
Screen Size15"

Jautājumi par šo preci

How do I connect the EJ070NA-01J driver board to a Raspberry Pi B+ 2 3?

Connect the board to the Raspberry Pi GPIO header using the supplied ribbon cable, align pin 1 with the square pad, then enable the DPI interface in config.txt; the step most people miss is setting the correct 1024x600 timing values.

Will the 5-wire resistive touchscreen need recalibration or replacement over time?

The 5-wire resistive layer can drift after heavy use; recalibrate via the OS input tools when accuracy drops, and expect the overlay to wear out after roughly 1 million touches, at which point the panel must be swapped.

Arī šajā sadaļā

Klienti arī salīdzināja

Tas pats plaukts, tā pati kase — astoņas kriptovalūtas un kursa fiksēšana uz 30 minūtēm.