暗号資産でのお支払いに対応—お手持ちのコインで、本物のハードウェアをご購入いただけます。暗号資産で支払い、本物のハードウェアに使う。 $399以上のご注文で、世界中どこでも送料無料（保険付き）。無地・ノーブランドの外箱で、ドイツから発送いたします。$399以上で送料無料（保険付き）。 注文手続きを開始すると、レートは30分間ロックされます。レートは30分間ロック。 すべての商品は未開封で、シリアル番号を確認した上で、24か月保証が付いています。未開封、24か月保証。

ウォッチリスト ログイン
Green rectangular driver board with HDMI and USB connectors beside a 7 inch LCD panel

Hetai Tech

Hetai Tech 7 inch 1024*600 EJ070NA-01J LCD Driver Board

SKU CH-ATYB-KF5KD

A 7-inch driver board with 1024×600 resolution and 5-wire resistive touchscreen for Raspberry Pi and other mini computers

  • Monitor TypeTouchscreen Monitor
  • Touchscreen Type5-wire Resistive
  • Screen Size15"
  • 7 inch 1024*600 resolution for sharp visuals
  • 5-wire resistive touchscreen enables precise input
  • Compatible with Raspberry Pi B+ 2 3 and Banana/Orange Pi
  • Good quality driver board ensures reliable operation

7 inch 1024*600 LCD driver board

This 7 inch 1024*600 EJ070NA-01J LCD driver board drives a 15 inch touchscreen monitor with a 5-wire resistive panel. It is built for makers connecting a display to Raspberry Pi or Banana/Orange Pi mini computers. The board is supplied new and intended for IoT edge and development projects.

Thermals noise and power

The board draws low power in normal operation and runs silently without active cooling. Heat output is minimal during typical display use. No fan or radiator is required for standard workloads.

特長

  • 7 inch 1024*600 resolution for sharp visuals
  • 5-wire resistive touchscreen enables precise input
  • Compatible with Raspberry Pi B+ 2 3 and Banana/Orange Pi
  • Good quality driver board ensures reliable operation

仕様

Monitor TypeTouchscreen Monitor
Touchscreen Type5-wire Resistive
Screen Size15"

この商品に関する質問

How do I connect the EJ070NA-01J driver board to a Raspberry Pi B+ 2 3?

Connect the board to the Raspberry Pi GPIO header using the supplied ribbon cable, align pin 1 with the square pad, then enable the DPI interface in config.txt; the step most people miss is setting the correct 1024x600 timing values.

Will the 5-wire resistive touchscreen need recalibration or replacement over time?

The 5-wire resistive layer can drift after heavy use; recalibrate via the OS input tools when accuracy drops, and expect the overlay to wear out after roughly 1 million touches, at which point the panel must be swapped.

同じ売り場の商品

よく比較されている商品

同じ売り場、同じレジ — 8種類のコインと30分間のレートロック。