Mēs pieņemam kriptovalūtu — lai tā, kas Jums pieder, varētu nopirkt īstu aparatūru.Maksājiet kriptovalūtā, iztērējiet to īstai aparatūrai. Bezmaksas apdrošināta piegāde visā pasaulē virs 399 $. Vienkāršas, nemarķētas kastes, sūtītas no Vācijas.Bezmaksas apdrošināta piegāde virs 399 $. Jūsu kurss tiek fiksēts uz 30 minūtēm, tiklīdz atveras kase.Kurss fiksēts uz 30 minūtēm. Katra prece ir aizzīmogota, tās sērijas numurs ir pārbaudīts, un uz to attiecas 24 mēnešu garantija.Aizzīmogots, 24 mēnešu garantija.

Uzraudzītās preces Pieteikties
Rectangular metal AT power supply unit, matte finish

KHACHIMO

KHACHIMO AT Power Supply 300W SPI-300G SD-250AT

SKU CH-9VG6-6VCD3

AT power supply delivering 300 watts for P8 and P9 systems

  • TypeATX
  • 300 W output powers legacy AT systems
  • 250 W continuous rating supports stable operation
  • ATX form factor fits standard chassis
  • Tested working for reliable performance

Compatible AT power supply for legacy systems

This 300 W AT-type unit carries the SPI-300G and SD-250AT designations and is tested working before dispatch. It is intended for older PCs that still use the P8 and P9 motherboard connectors rather than modern ATX plugs.

P8 and P9 connectors replace standard ATX headers

The bundled wiring harness provides the two six-pin blocks required by classic AT mainboards, removing the need for adapters. Builders working on vintage hardware can install the unit directly, while anyone with a current ATX board will find the connector layout unsuitable.

Priekšrocības

  • 300 W output powers legacy AT systems
  • 250 W continuous rating supports stable operation
  • ATX form factor fits standard chassis
  • Tested working for reliable performance

Specifikācijas

TypeATX

Jautājumi par šo preci

Will the internal fan need periodic cleaning or eventual replacement on the SPI-300G?

The 300 W AT supply uses a standard cooling fan; dust buildup should be cleared every few months and the fan itself typically lasts several years before bearing wear requires a swap.

Which limit appears first when the SD-250AT runs continuously at full load?

The 250 W continuous rating is reached before the 300 W peak, so sustained output is capped at the lower figure and the protection circuit will engage if that level is exceeded.

Arī šajā sadaļā

Klienti arī salīdzināja

Tas pats plaukts, tā pati kase — astoņas kriptovalūtas un kursa fiksēšana uz 30 minūtēm.