KingSpec NT-1TB-2242 1TB M.2 SATA 2242 internal SSD
- Internal Solid Stat…
- Consumer
Mēs pieņemam kriptovalūtu — lai tā, kas Jums pieder, varētu nopirkt īstu aparatūru.Maksājiet kriptovalūtā, iztērējiet to īstai aparatūrai. Bezmaksas apdrošināta piegāde visā pasaulē virs 399 $. Vienkāršas, nemarķētas kastes, sūtītas no Vācijas.Bezmaksas apdrošināta piegāde virs 399 $. Jūsu kurss tiek fiksēts uz 30 minūtēm, tiklīdz atveras kase.Kurss fiksēts uz 30 minūtēm. Katra prece ir aizzīmogota, tās sērijas numurs ir pārbaudīts, un uz to attiecas 24 mēnešu garantija.Aizzīmogots, 24 mēnešu garantija.
KingSpec
M.2 2280 SATA internal SSD with 512 GB capacity, 3D NAND, up to 560 MB/s read and 540 MB/s write, 58,800 random read IOPS, 62,500 random write IOPS, 1.5 W idle power and 1,000,000-hour MTBF
Model NT-512-2280
The KingSpec NT-512-2280 is a 512GB internal solid-state drive built in the M.2 2280 form factor with a SATA III 6Gb/s interface. It uses 3D NAND flash and a controller rated for up to 560 MB/s sequential read and 540 MB/s sequential write speeds. Random performance reaches 58,800 IOPS read and 62,500 IOPS write.
This drive fits desktops, laptops and ultrabooks that provide an M.2 slot wired for SATA signalling. The 3.50mm height and 22mm by 80mm dimensions match the standard 2280 footprint. Systems that require PCIe signalling on the M.2 connector cannot use this drive. Buyers should verify their motherboard or laptop manual lists SATA support for the M.2 socket before purchasing.
The single specification that determines whether this part works is the SATA III 6Gb/s interface protocol. The M.2 2280 connector shape is shared with faster PCIe drives, but this unit communicates only over SATA. If the host slot is keyed or configured exclusively for PCIe, the SSD will not be detected.
| Brand | KingSpec |
|---|---|
| Series | NT 2280 Series |
| Model | NT-512-2280 |
| Part Number | NT-512-2280 |
| Device Type | Internal Solid State Drive (SSD) |
| Used For | Consumer |
| Form Factor | M.2 2280 |
| Capacity | 512GB |
| Memory Components | 3D NAND |
| Interface | SATA III |
| Max Sequential Read | Up to 560 MBps |
| Max Sequential Write | Up to 540 MBps |
| 4KB Random Read | Up to 58,800 IOPS |
| 4KB Random Write | Up to 62,500 IOPS |
| MTBF | 1,000,000 hours |
| HeatSink | without HeatSink |
| Power Consumption (Idle) | 1.5W |
| Operating Temperature | 0°C ~ +70°C |
| Storage Temperature | -20°C ~ +75°C |
| Height | 3.50mm |
| Width | 22.00mm |
| Depth | 80.00mm |
| Weight | 50g |
Citas šī modeļa versijas
Viena saime, taču atšķirīga atmiņa, dzesētājs vai frekvence — salīdziniet, pirms izlemjat.
The 560 MBps figure is the peak SATA III throughput; in a laptop the drive will deliver near that speed for large file transfers and boot sequences, limited by the SATA bus ceiling.
The SATA III link tops out at 6 Gb/s, so sequential reads and writes cannot exceed roughly 560 MBps and 540 MBps respectively, regardless of the 3D NAND or controller.
The drive measures 22 mm wide by 80 mm long and 3.50 mm high, fitting any standard M.2 2280 slot secured with a single screw.
Arī šajā sadaļā
Tas pats plaukts, tā pati kase — astoņas kriptovalūtas un kursa fiksēšana uz 30 minūtēm.
Kriptovalūta, kurā maksājat, un valūta, kurā redzat cenas.
Nosūtīts no Jūsu maciņa, noformējot pasūtījumu
Tikai informatīvi — katalogā cenas norādītas ASV dolāros
Neviena valūta neatbilst.
Izvēlieties valodu, kurā vietne sarunājas ar Jums.
Pirmo reizi šeit?
Jau ir konts?
Automātiskas atiestatīšanas nav: šis veikals nesūta e-pastus, tāpēc nav arī vienreizējas saites, ko pieprasīt. Atstājiet adresi kontā, un tā tiks apstrādāta manuāli.
Pieprasījums saņemts
Uz Jūsu e-pastu nekas neatnāks — šis veikals vispār nesūta e-pastus. Kāds šos pieprasījumus apstrādā manuāli.
Atcerējāties?