LORDWORLD
LORDWORLD PCIe 3 Ports 1394A Firewire Adapter Low Profile Bracket
Adds three FireWire ports (two 6-pin, one 4-pin) via a PCIe x1 slot with 2.5Gb/s throughput and IEEE 1394a 400/200/100Mbps support
- Adds three FireWire ports to a desktop via a single PCIe lane
- 5 Gb/s full-duplex PCIe 1.0a link keeps data flowing
- 400/200/100 Mbps IEEE 1394 speeds cover DV and legacy gear
- Low-profile bracket fits slim and standard cases alike
- OpenHCI 1.0/1.1 compliance ensures broad OS and device support
PCIe 1394A FireWire Adapter
The LORDWORLD adapter adds three IEEE 1394A ports to a desktop PC through a single-lane PCI Express 1.0a slot. It is intended for users who need to connect legacy DV cameras, external hard drives or other FireWire 400 devices to a modern system.
Low-profile bracket and port mix
A low-profile bracket is included for small-form-factor cases, while the rear panel provides two 6-pin and one 4-pin connectors. The card draws power from the slot itself, so no external power cable is required, but the controller does not support hot-plugging; the system must be powered off before devices are attached or removed.
Thermals, noise and power draw
As a passive controller card with no onboard fan, it produces no audible noise and adds negligible heat to the chassis. Power consumption is limited to the PCIe x1 slot envelope, making it compatible with standard desktop power supplies without extra connectors.
Priekšrocības
- Adds three FireWire ports to a desktop via a single PCIe lane
- 5 Gb/s full-duplex PCIe 1.0a link keeps data flowing
- 400/200/100 Mbps IEEE 1394 speeds cover DV and legacy gear
- Low-profile bracket fits slim and standard cases alike
- OpenHCI 1.0/1.1 compliance ensures broad OS and device support
Specifikācijas
| Brand | LORDWORLD |
|---|
Jautājumi par šo preci
What PCIe lane width and revision does this card use, and what practical throughput does that cap?
It uses a single x1 lane compliant with PCI-Express Revision 1.0a, giving a 2.5 Gb/s full-duplex channel that limits total bandwidth to that rate.
What bracket and slot dimensions are needed to mount this adapter?
A standard low-profile bracket is included; the card occupies one x1 or larger PCIe slot and requires the rear-panel cut-out for three external ports (two 6-pin, one 4-pin).
How is the card installed, and what step do users often miss?
Power off the PC, insert the card into a free x1 slot, secure the low-profile bracket, then connect devices — hot-plugging is not supported, so power must stay off until the card is fully seated.
Arī šajā sadaļā
Klienti arī salīdzināja
Tas pats plaukts, tā pati kase — astoņas kriptovalūtas un kursa fiksēšana uz 30 minūtēm.
Black Box Corporation DisplayPort to DVI Fibre Optic Cable 15 ft 4.5 m 1.35 GB/s
- Consumer Electronics



