Mēs pieņemam kriptovalūtu — lai tā, kas Jums pieder, varētu nopirkt īstu aparatūru.Maksājiet kriptovalūtā, iztērējiet to īstai aparatūrai. Bezmaksas apdrošināta piegāde visā pasaulē virs 399 $. Vienkāršas, nemarķētas kastes, sūtītas no Vācijas.Bezmaksas apdrošināta piegāde virs 399 $. Jūsu kurss tiek fiksēts uz 30 minūtēm, tiklīdz atveras kase.Kurss fiksēts uz 30 minūtēm. Katra prece ir aizzīmogota, tās sērijas numurs ir pārbaudīts, un uz to attiecas 24 mēnešu garantija.Aizzīmogots, 24 mēnešu garantija.

Uzraudzītās preces Pieteikties
Green rectangular circuit board with gold edge connector and black memory chips, no heat spreader

OWC

OWC 8GB DDR4 2400MHz CL17 1.2V 260-pin SODIMM for HP ProDesk 400 G3 Mini 600 G3 Mini

SKU CH-81EX-0JMCR

8GB DDR4 2400MHz CL17 SODIMM upgrades HP ProDesk 400 G3 Mini and 600 G3 Mini systems

  • Capacity8GB
  • Type260-Pin DDR4 Non-ECC SODIMM
  • SpeedDDR4 2400 (PC4 19200)
  • CAS LatencyCL17
  • Voltage1.2V
  • ECCNo
  • Boosts system responsiveness with 8GB DDR4 2400MHz speed
  • Low 1.2V voltage cuts power draw and heat
  • CL17 latency ensures quick data access for multitasking
  • JEDEC compliant for reliable HP ProDesk 400 G3 Mini and 600 G3 Mini fit
  • 260-pin SODIMM form factor enables straightforward DIY installation

8GB DDR4 SODIMM for HP ProDesk Mini

This 8GB DDR4 module is built specifically for the HP ProDesk 400 G3 Mini and 600 G3 Mini. It uses a 260-pin SODIMM form factor that fits the compact chassis of these systems. The kit targets owners of these exact models who need a straightforward memory increase.

Upgrade from lower capacity or slower DDR4

The module replaces an existing stick or fills an empty slot to raise total memory. It runs at 2400MHz with CL17 timing and 1.2V voltage. The jump is worth it when the current configuration limits multitasking or forces excessive paging on these supported platforms.

Limited by DDR4 SODIMM speed ceiling

The DDR4 2400 standard caps the data rate at 2400MHz, so this module cannot exceed that ceiling. It is backwards compatible with 2133MHz operation if the system requires it. Builders needing higher bandwidth or a different form factor cannot use this part.

Priekšrocības

  • Boosts system responsiveness with 8GB DDR4 2400MHz speed
  • Low 1.2V voltage cuts power draw and heat
  • CL17 latency ensures quick data access for multitasking
  • JEDEC compliant for reliable HP ProDesk 400 G3 Mini and 600 G3 Mini fit
  • 260-pin SODIMM form factor enables straightforward DIY installation

Specifikācijas

BrandOWC
Part Number2S4D41R808GB
Capacity8GB
Type260-Pin DDR4 Non-ECC SODIMM
SpeedDDR4 2400 (PC4 19200)
CAS LatencyCL17
Voltage1.2V
ECCNo
Buffered/RegisteredUnbuffered
Rank1Rx8
Heat SpreaderNo
Compatible SystemHP ProDesk 400 G3 Mini
HP ProDesk 600 G3 Mini

Citas šī modeļa versijas

Vēl 5 šajā sērijā

Viena saime, taču atšķirīga atmiņa, dzesētājs vai frekvence — salīdziniet, pirms izlemjat.

Jautājumi par šo preci

Will the 260-pin SODIMM fit inside the HP ProDesk 400 G3 Mini chassis?

Yes, the module is a 260-pin DDR4 SODIMM designed for the HP ProDesk 400 G3 Mini and 600 G3 Mini, matching the slot and 1.2V power requirement of those systems.

What is the correct way to seat the module so it locks in place?

Align the notch on the 260-pin edge connector with the key in the slot, insert at a slight angle, then press down firmly until the side clips click — the step often missed is pressing evenly on both ends until both clips engage.

Does this 8GB DDR4 2400MHz CL17 module need any firmware updates or periodic replacement?

No firmware is required; the JEDEC-compliant DDR4 SODIMM runs at 1.2V with CL17 timing and is rated for the life of the system, so no scheduled replacement is needed.

Arī šajā sadaļā

Klienti arī salīdzināja

Tas pats plaukts, tā pati kase — astoņas kriptovalūtas un kursa fiksēšana uz 30 minūtēm.