Mēs pieņemam kriptovalūtu — lai tā, kas Jums pieder, varētu nopirkt īstu aparatūru.Maksājiet kriptovalūtā, iztērējiet to īstai aparatūrai. Bezmaksas apdrošināta piegāde visā pasaulē virs 399 $. Vienkāršas, nemarķētas kastes, sūtītas no Vācijas.Bezmaksas apdrošināta piegāde virs 399 $. Jūsu kurss tiek fiksēts uz 30 minūtēm, tiklīdz atveras kase.Kurss fiksēts uz 30 minūtēm. Katra prece ir aizzīmogota, tās sērijas numurs ir pārbaudīts, un uz to attiecas 24 mēnešu garantija.Aizzīmogots, 24 mēnešu garantija.

Uzraudzītās preces Pieteikties
Grey ATX power supply unit with single fan

Replace Power

Replace Power AP-MPS3ATX30-30 300W ATX power supply

SKU CH-WD36-PSPYD MPN AP-MPS3ATX30-30

A 300 W ATX power supply with 20+4-pin, 4-pin ATX12V, three SATA, two peripheral and one floppy connector, plus over-voltage protection

  • ColorGrey
  • TypeATX
  • Fans1
  • Weight0.1
  • 300W steady output powers desktop builds reliably
  • High efficiency design reduces wasted energy and heat
  • Low ripple and noise protects sensitive components
  • Over-voltage protection guards hardware from power spikes
  • Multiple connectors including SATA support varied drive configurations

300W ATX replacement unit

This 300W ATX power supply replaces the Sparkle FSP300-60PLN in compatible desktop systems. It provides a direct swap for ageing or failed units in office PCs and basic workstations. The grey enclosure houses a single cooling fan. Builders needing higher wattage or modular cabling should look elsewhere.

Sustained 300W output with protection

The unit delivers a steady 300W stream rather than a short burst rating. High efficiency and low ripple and noise keep voltage stable during extended workloads. Output over-voltage protection guards connected components if the regulation loop drifts. Continuous operation at full load is supported within the design limits.

Fixed cable set with legacy connectors

A 20+4-pin ATX connector and a 4-pin ATX12V connector power the motherboard and CPU. Two peripheral connectors, one floppy connector and three SATA connectors cover drives and older accessories. All cables are fixed, so unused leads remain inside the case. The compact 0.1kg chassis fits standard ATX mounting points.

Priekšrocības

  • 300W steady output powers desktop builds reliably
  • High efficiency design reduces wasted energy and heat
  • Low ripple and noise protects sensitive components
  • Over-voltage protection guards hardware from power spikes
  • Multiple connectors including SATA support varied drive configurations

Specifikācijas

BrandReplace Power
ModelAP-MPS3ATX30-30
ColorGrey
TypeATX
Fans1
Weight0.1

Jautājumi par šo preci

How much heat and noise should I expect from the single fan when the 300W unit runs all day?

The single fan cools the 300W unit; with high efficiency and low ripple and noise the unit stays quiet under typical desktop loads.

Which motherboard power connectors must my board already provide for this PSU to work?

Your board needs a 20+4-pin ATX socket and a 4-pin ATX12V socket; the PSU also includes two peripheral, one floppy and three SATA power connectors for drives.

Will the 20+4-pin ATX and 4-pin ATX12V connectors fit an older motherboard that only has a 20-pin and a 4-pin socket?

Yes, the 20+4-pin plug splits to match a 20-pin socket and the 4-pin ATX12V connector fits the older 4-pin header directly.

Arī šajā sadaļā

Klienti arī salīdzināja

Tas pats plaukts, tā pati kase — astoņas kriptovalūtas un kursa fiksēšana uz 30 minūtēm.