WMtec
WMtec DPS-500YB 500W 1U Server Power Supply
Delivers 500 W continuous and up to 600 W peak from a 1U rack-mount chassis with 24-pin, dual 8-pin, SATA and custom 10-pin connectors
- 500 W continuous output with 600 W peak capacity
- 1U rack-mount form factor fits standard server chassis
- 24-pin, dual 8-pin and SATA connectors cover motherboard and drives
- Custom 10-pin interface converts to 4-pin and extra SATA power
- 24 cm depth allows installation in shallow rack enclosures
500 W 1U rack server supply
The WMtec DPS-500YB is a 500 W rack-mounted 1U server power supply built for compact enterprise chassis. It delivers 24-pin, dual 8-pin, two SATA and one custom 10-pin connector that breaks out to a large 4-pin and additional SATA. The unit suits administrators fitting dense 1U racks with standard ATX-derived cabling.
Sustained 500 W with 600 W peak headroom
Rated output holds at 500 W during continuous operation while short-term peaks can reach 600 W under test conditions. The 1U form factor keeps airflow aligned with server ducting so thermal load stays predictable during extended compute runs. Steady voltage regulation supports constant disk-array and CPU workloads without throttle cycles.
Replaces failed or undersized 1U units
This supply fits slots where an existing 500 W 1U module has degraded or where a lower-wattage unit cannot drive added drives and expansion cards. The custom 10-pin breakout covers proprietary backplane pins that generic ATX units lack. Buyers needing redundant hot-swap frames or higher continuous wattage should verify chassis compatibility before purchase.
Priekšrocības
- 500 W continuous output with 600 W peak capacity
- 1U rack-mount form factor fits standard server chassis
- 24-pin, dual 8-pin and SATA connectors cover motherboard and drives
- Custom 10-pin interface converts to 4-pin and extra SATA power
- 24 cm depth allows installation in shallow rack enclosures
Specifikācijas
Šai precei pagaidām nav publicētu specifikāciju.
Jautājumi par šo preci
How loud does the DPS-500YB get when it runs at 500W all day?
The unit is a rack-mounted 1U server power supply rated at 500W with a peak test of 600 watts; its internal fan speed scales with load and temperature inside the chassis.
What cables or connectors must I already have to install this power supply?
It uses a 24-pin main connector, two 8-pin CPU connectors, two SATA connectors and a custom 10-pin interface that converts to a large 4-pin and extra SATA.
Will the DPS-500YB work in a chassis that still uses older SATA drives?
Yes, the supply provides two standard SATA power connectors alongside the custom 10-pin breakout, so existing SATA drives can be powered directly.
Arī šajā sadaļā
Klienti arī salīdzināja
Tas pats plaukts, tā pati kase — astoņas kriptovalūtas un kursa fiksēšana uz 30 minūtēm.
