Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Silver rectangular 1U server power supply unit with rear connector panel

WMtec

WMtec DPS-500YB 500W 1U Server Power Supply

SKU CH-WNNV-CHH1T

Delivers 500 W continuous and up to 600 W peak from a 1U rack-mount chassis with 24-pin, dual 8-pin, SATA and custom 10-pin connectors

  • 500 W continuous output with 600 W peak capacity
  • 1U rack-mount form factor fits standard server chassis
  • 24-pin, dual 8-pin and SATA connectors cover motherboard and drives
  • Custom 10-pin interface converts to 4-pin and extra SATA power
  • 24 cm depth allows installation in shallow rack enclosures

500 W 1U rack server supply

The WMtec DPS-500YB is a 500 W rack-mounted 1U server power supply built for compact enterprise chassis. It delivers 24-pin, dual 8-pin, two SATA and one custom 10-pin connector that breaks out to a large 4-pin and additional SATA. The unit suits administrators fitting dense 1U racks with standard ATX-derived cabling.

Sustained 500 W with 600 W peak headroom

Rated output holds at 500 W during continuous operation while short-term peaks can reach 600 W under test conditions. The 1U form factor keeps airflow aligned with server ducting so thermal load stays predictable during extended compute runs. Steady voltage regulation supports constant disk-array and CPU workloads without throttle cycles.

Replaces failed or undersized 1U units

This supply fits slots where an existing 500 W 1U module has degraded or where a lower-wattage unit cannot drive added drives and expansion cards. The custom 10-pin breakout covers proprietary backplane pins that generic ATX units lack. Buyers needing redundant hot-swap frames or higher continuous wattage should verify chassis compatibility before purchase.

Kohokohdat

  • 500 W continuous output with 600 W peak capacity
  • 1U rack-mount form factor fits standard server chassis
  • 24-pin, dual 8-pin and SATA connectors cover motherboard and drives
  • Custom 10-pin interface converts to 4-pin and extra SATA power
  • 24 cm depth allows installation in shallow rack enclosures

Tekniset tiedot

Tälle tuotteelle ei ole vielä julkaistu teknisiä tietoja.

Kysymyksiä tästä tuotteesta

How loud does the DPS-500YB get when it runs at 500W all day?

The unit is a rack-mounted 1U server power supply rated at 500W with a peak test of 600 watts; its internal fan speed scales with load and temperature inside the chassis.

What cables or connectors must I already have to install this power supply?

It uses a 24-pin main connector, two 8-pin CPU connectors, two SATA connectors and a custom 10-pin interface that converts to a large 4-pin and extra SATA.

Will the DPS-500YB work in a chassis that still uses older SATA drives?

Yes, the supply provides two standard SATA power connectors alongside the custom 10-pin breakout, so existing SATA drives can be powered directly.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.