Brute Networks
Brute Networks 32GB DDR4 2933 ECC Registered RDIMM 2Rx4 1.2V Dell AB552575
32 GB DDR4 ECC registered server memory running at 2933 MHz with 1.2 V operation
- Capacity32GB
- Type288-Pin DDR4 SDRAM
- SpeedDDR4 2933 (PC4 23400)
- Voltage1.20V
- ECCYes
- Buffered/RegisteredRegistered
- 32GB capacity supports demanding server workloads
- DDR4 2933 speed delivers high data throughput
- ECC registered design protects data integrity
- 2V operation reduces power consumption
- 288-pin RDIMM fits compatible Dell servers
32GB DDR4-2933 ECC Registered RDIMM
This 32GB DDR4 module runs at 2933 MT/s with ECC and registered buffering. It uses a 2Rx4 organisation and operates at 1.20 volts across 288 pins. The part is built with major-brand DRAM and matches Dell part number AB552575 for drop-in server upgrades.
Suits Dell servers needing 32GB registered ECC DIMMs
Administrators expanding memory in compatible Dell platforms will find this module a direct match. Systems that require unbuffered UDIMMs, lower densities, or non-ECC memory cannot use this registered 2Rx4 design. Buyers needing different speeds or capacities should verify their platform requirements first.
Registered 2Rx4 ECC at 1.20V decides fit
The registered 2Rx4 ECC architecture at 1.20V is the single specification that determines whether this DIMM works in a given server. Only platforms that support registered DDR4-2933 ECC modules with this exact organisation will accept it.
Ciri-ciri utama
- 32GB capacity supports demanding server workloads
- DDR4 2933 speed delivers high data throughput
- ECC registered design protects data integrity
- 2V operation reduces power consumption
- 288-pin RDIMM fits compatible Dell servers
Spesifikasi
| Brand | Dell |
|---|---|
| Capacity | 32GB |
| Type | 288-Pin DDR4 SDRAM |
| Speed | DDR4 2933 (PC4 23400) |
| Voltage | 1.20V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Chipset | Major Brand Chipset |
Soalan tentang produk ini
Does my server need 288-pin DDR4 slots to install this 32GB RDIMM?
Yes, this module uses the standard 288-pin DDR4 form factor and requires a server motherboard with registered DIMM slots that support ECC memory.
Can I mix this 2Rx4 registered module with existing single-rank RDIMMs in the same system?
Mixing ranks is often possible but depends on your server's memory controller and population rules; consult the platform's qualified vendor list for supported rank combinations.
How do I confirm the module is running at 2933 MT/s with ECC active after installation?
Check the BIOS memory information screen or use a tool like dmidecode to verify the configured speed shows 2933 MT/s and that ECC status reports as enabled or active.
Juga di rak ini
Pelanggan turut membandingkan
Rak yang sama, checkout yang sama — lapan koin kripto dan kunci kadar 30 minit.



