Computer Memory Solutions CM1024642400DIMM 16GB (2x8GB) DDR4 2400 CL17 1.2V 288-Pin DIMM

Compatible DDR4 Kit for EVGA Stinger Boards

This 16 GB kit contains two 8 GB DDR4 2400 modules validated for EVGA Z170 Stinger and Z270 Stinger motherboards. The unbuffered non‑ECC DIMMs run at 1.2 V with CL17 timings. They install directly into the two available slots to reach the board’s 32 GB maximum. Builders upgrading these specific mini‑ITX platforms gain a straightforward capacity increase.

Unbuffered 288‑Pin Modules Without Heat Spreaders

Each stick uses a standard 288‑pin DDR4 form factor and major‑brand chips in a 2Rx8 layout. The absence of a heat spreader keeps the profile low, which helps inside compact Stinger cases where clearance is tight. Gold‑edge connectors mate cleanly with the board’s two DIMM sockets. Installation requires no extra cables or brackets, so the upgrade finishes in minutes.

Replaces Lower‑Capacity

The kit fills both slots to hit the 32 GB ceiling supported by the Z170 and Z270 Stinger models. If the system currently runs a single 8 GB stick or slower memory, this matched pair restores dual‑channel bandwidth and raises the ceiling for multitasking. Buyers needing more than 32 GB or ECC functionality must choose a different platform.