OEM Industries
OEM Industries UDQFHBB03F 3010 5V .1A 3-Wire CPU Cooler
A compact 30 mm square fan with ball bearing and 3-pin 5 V 0.1 A power for tight CPU cooling spaces
- Color2-Tone
- TypeFan only
- Fan Size30mm
- Bearing TypeBall
- Power Connector3 Pin
- LEDNo
- 30 mm square fan fits tight spaces
- Ball bearing runs quietly and lasts longer
- 5 V 0.1 A draw keeps power use low
- 3-pin connector works with standard motherboard headers
- Panaflo 3010 design built for reliable cooling
Compact 30 mm square cooler
The OEM Industries UDQFHBB03F is a low-profile Panaflo 3010 fan designed for tight spaces where a full-size CPU cooler cannot fit. It draws 5 V at 0.1 A through a standard three-pin connector, making it suitable for embedded boards, small-form-factor systems or secondary component cooling.
Steady airflow with ball-bearing reliability
Ball bearings keep the rotor stable during continuous operation, avoiding the wear that sleeve bearings show under sustained load. The 30 mm frame moves air consistently across heatsinks or chassis zones without the speed drop-off seen in smaller blowers.
Two-tone frame mounts in any orientation
The square 30 mm by 10 mm body uses four corner holes for direct screw mounting to a heatsink or case panel. No LED lighting means no extra cables, and the three-wire lead reports speed to the motherboard for automatic fan-curve control.
Ciri-ciri utama
- 30 mm square fan fits tight spaces
- Ball bearing runs quietly and lasts longer
- 5 V 0.1 A draw keeps power use low
- 3-pin connector works with standard motherboard headers
- Panaflo 3010 design built for reliable cooling
Spesifikasi
| Model | UDQFHBB03F |
|---|---|
| Color | 2-Tone |
| Type | Fan only |
| Fan Size | 30mm |
| Bearing Type | Ball |
| Power Connector | 3 Pin |
| LED | No |
Soalan tentang produk ini
How much power does the 5 V 0.1 A motor draw during continuous use?
It draws 0.1 A at 5 V, so the motor consumes very little energy even when running all day.
Which header on my motherboard fits the 3-pin connector on this cooler?
Plug the 3-pin connector into any standard 3-pin or 4-pin fan header on the board.
Will the 30×10 mm square frame line up with the mounting holes on my existing CPU bracket?
The 3010 footprint matches coolers that use the same 30 mm square hole pattern.
Juga di rak ini
Pelanggan turut membandingkan
Rak yang sama, checkout yang sama — lapan koin kripto dan kunci kadar 30 minit.
ModMyMods MOD-0002 3/8" ID x 1/2" OD Clear PVC Tubing DIY Cooling
- Clear



