OWC 16GB (2x8GB) DDR4 2666 CL19 ECC SODIMM 260-pin 1.2V Synology RS1522+ memory upgrade
- 16GB (2 x 8GB)
- 260-Pin DDR4 ECC SO…
Kami menerima kripto — jadi koin yang anda simpan boleh membeli perkakasan sebenar.Bayar dengan kripto, belanjakannya untuk perkakasan sebenar. Penghantaran berinsurans percuma ke seluruh dunia untuk belian melebihi USD 399. Kotak biasa tanpa jenama, dihantar dari Jerman.Penghantaran berinsurans percuma untuk belian melebihi USD 399. Kadar anda dikunci selama 30 minit sebaik sahaja proses pesanan bermula.Kadar dikunci selama 30 minit. Setiap item disegel, nombor sirinya disemak, dan dilindungi waranti 24 bulan.Disegel, waranti 24 bulan.
OWC
32 GB dual-channel DDR4 2666 ECC SODIMM kit validated for Synology RS1522+ NAS upgrades
Capacity 32GB (2 x 16GB)
This 32GB kit contains two 16GB DDR4 2666 ECC SODIMM modules built for the Synology DiskStation RS1522+. Each stick runs at PC4-21300 with CL19 timing at 1.2V and uses a 2Rx8 unbuffered layout. The 260-pin form factor fits the NAS memory slots directly.
The modules meet JEDEC standards and RoHS requirements, so the upgrade keeps the original system warranty intact. Backward compatibility with 2400MHz and 2133MHz buses allows the kit to run in older slots without configuration changes. No heat spreader is included, matching the factory design.
The 32GB pool handles simultaneous file shares, Docker containers and virtual machines on the RS1522+ without paging. ECC protection corrects single-bit errors that can corrupt data in always-on storage. Workloads that exceed 32GB will still require a higher-capacity platform.
| Brand | OWC |
|---|---|
| Part Number | 2C6D42R8032P |
| Capacity | 32GB (2 x 16GB) |
| Type | 260-Pin DDR4 ECC SODIMM |
| Speed | DDR4 2666 (PC4 21300) |
| CAS Latency | CL19 |
| Voltage | 1.2V |
| ECC | Yes |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Heat Spreader | No |
| Compatible System | Synology DiskStation RS1522+ |
Versi lain model ini
Keluarga yang sama, memori, penyejuk atau kelajuan jam yang berbeza — bandingkan sebelum membuat keputusan.
No, the DDR4 ECC modules are passive components with no firmware. They are designed to remain in place for the lifetime of the NAS unless a capacity upgrade is desired.
The CL19 latency at 2666 MT/s sets the bandwidth ceiling. If the workload exceeds the 32 GB capacity, the system will swap to disk, which is the practical performance limit.
Each module runs at 1.2 V without a heat spreader. The JEDEC-standard DDR4 design keeps thermal output low enough for the RS1522+ standard cooling.
Juga di rak ini
Rak yang sama, checkout yang sama — lapan koin kripto dan kunci kadar 30 minit.
Apa yang anda hantar untuk membayar, dan mata wang yang anda guna untuk membaca harga.
Dihantar daripada dompet anda semasa semak keluar
Untuk paparan sahaja — katalog diberi harga dalam USD
Tiada mata wang yang sepadan.
Pilih bahasa yang digunakan oleh laman web ini.
Tiada bahasa yang sepadan.
Pengguna baharu?
Sudah mempunyai akaun?
Tiada set semula automatik: kedai ini tidak menghantar sebarang e-mel, jadi tiada pautan sekali guna untuk diminta. Biarkan alamat pada akaun tersebut, ia akan diuruskan secara manual.
Permintaan direkodkan
Tiada apa-apa akan sampai ke peti masuk anda — kedai ini tidak menghantar sebarang e-mel. Seseorang akan menguruskannya secara manual.
Sudah teringat?