Intel
Intel D3-S4510 1.92TB SATA 2.5" enterprise SSD
1.92 TB enterprise SATA SSD with 560 MB/s reads, 510 MB/s writes, 256-bit encryption and 7 mm z-height
- Form Factor2.5"
- Capacity1.92TB
- Memory Components3D NAND
- InterfaceSATA III
- 92 TB capacity for large server datasets
- 560 MB/s read speed accelerates data access
- 510 MB/s write speed sustains heavy workloads
- 256-bit encryption protects stored information
- 7 mm z-height fits dense 2.5-inch bays
Enterprise SATA SSD for read-heavy workloads
The Intel D3-S4510 is a 1.92TB internal solid-state drive built for servers and storage arrays. It uses 3D NAND flash memory and connects through a standard SATA III interface. The 2.5-inch form factor fits 7mm drive bays in compatible chassis.
Suited for sequential read tasks
This drive delivers up to 560 MB/s read and 510 MB/s write speeds over the 600 MB/s SATA link. End-to-end data protection and enhanced power-loss protection help preserve data integrity. Teams needing higher throughput or lower latency than the SATA bus provides should consider a different interface.
Deciding spec: 1.92TB capacity on a SATA III bus
The single figure that determines fit is the 1.92TB capacity combined with the SATA III interface. It defines the maximum storage space available at SATA transfer rates. Verify the server backplane supports 2.5-inch SATA drives before ordering.
Öne çıkanlar
- 92 TB capacity for large server datasets
- 560 MB/s read speed accelerates data access
- 510 MB/s write speed sustains heavy workloads
- 256-bit encryption protects stored information
- 7 mm z-height fits dense 2.5-inch bays
Teknik özellikler
| Brand | Intel |
|---|---|
| Series | D3-S4510 |
| Model | SSDSC2KB019T801 |
| Form Factor | 2.5" |
| Capacity | 1.92TB |
| Memory Components | 3D NAND |
| Interface | SATA III |
Bu ürünle ilgili sorular
What does the SATA 600 interface cap the drive at in practice?
The SATA 600 interface limits sequential reads to 560 MB/s and writes to 510 MB/s.
Will the 7 mm z-height fit my 2.5 inch bay?
The 2.5 inch form factor with a 0.3 inch height fits standard 7 mm drive bays and hot-swap trays.
How is the drive installed and what step is often missed?
Connect the SATA data and power cables, secure the drive in the bay, then enable AHCI in the BIOS so the OS recognises the SSD.
Bu reyondan diğerleri
Müşteriler bunları karşılaştırdı
Aynı raf, aynı sipariş tamamlama — sekiz koin ve 30 dakikalık kur kilidi.
HP 628059-B21 3TB 7200 RPM SATA 3.0Gb/s 3.5" internal hard drive
- Bare Drive
- SATA 3.0Gb/s
Seagate Cheetah 10K.7 ST3300007LC 300GB 10000 RPM 8MB SCSI Ultra320 80pin 3.5" internal hard drive
- Bare Drive
- SCSI Ultra320 80pin
IBM 49Y2003 600GB 2.5" SAS 10000 RPM 16MB internal hard drive
- SAS 6Gb/s
- 10000 RPM



