Kripto para kabul ediyoruz — böylece elinizdeki koinlerle gerçek donanım alabilirsiniz.Kripto parayla ödeyin, onu gerçek donanıma harcayın. $399 üzeri siparişlerde dünya genelinde sigortalı kargo ücretsizdir. Sade, markasız koliler Almanya’dan gönderilir.$399 üzeri siparişlerde sigortalı kargo ücretsizdir. Ödeme sayfası açıldığında kurunuz 30 dakika kilitli kalır.Kur 30 dakika kilitli. Her ürün mühürlüdür, seri numarası kontrol edilir ve 24 ay garanti kapsamındadır.Mühürlü, 24 ay garantili.

Favori ürünler Giriş yap
Two green DDR5 RDIMM modules with black chips and gold contacts, no heat spreader

NEMIX RAM

NEMIX RAM 64GB 2x32GB DDR5 5600 CL46 1.1V 2Rx8 ECC Registered RDIMM Kit for Supermicro H14SSF memory upgrade

SKU CH-BTPA-6HWG6

64 GB dual-rank DDR5 registered ECC kit runs at 5600 MT/s with CL46 timing and 1.1 V for the Supermicro H14SSF motherboard

  • Capacity64GB (2 x 32GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 5600 (PC5 44800)
  • CAS LatencyCL46
  • Voltage1.10V
  • ECCYes

Size 64GB 2X32GB

24 yapılandırma daha gösterin
  • 64 GB capacity from a matched 2 × 32 GB kit for full server density
  • DDR5 5600 speed with CL46 latency runs at rated performance
  • 1 V operation lowers power draw per module
  • Registered ECC RDIMM corrects single-bit errors and buffers the memory bus
  • 288-pin form factor fits the Supermicro H14SSF motherboard exactly

Exact DDR5 RDIMM kit for Supermicro H14SSF

This 64 GB kit contains two 32 GB DDR5 5600 RDIMMs built to the exact rank, voltage and timing the H14SSF memory controller expects. Registered ECC architecture with CL46 latency and 1.1 V operation ensures the modules are recognised at full capacity and run at rated speed without manual tuning.

DDR5 5600 registered ECC limits

DDR5 5600 (PC5-44800) registered DIMMs require a motherboard that supports registered signalling and ECC correction; consumer boards that accept only unbuffered UDIMMs will not post with these modules. The 2Rx8 organisation and 1.1 V spec must match the platform's qualified-vendor list, otherwise the system may down-clock or refuse to boot.

Straightforward server DIMM installation

Power down the server, open the chassis and align each 288-pin module with the keyed slot following the motherboard's population order. Press firmly until both retention clips latch; a common mistake is seating only one side, which causes a memory error at POST. Verify the BIOS reports 64 GB at DDR5 5600 before closing the case.

Öne çıkanlar

  • 64 GB capacity from a matched 2 × 32 GB kit for full server density
  • DDR5 5600 speed with CL46 latency runs at rated performance
  • 1 V operation lowers power draw per module
  • Registered ECC RDIMM corrects single-bit errors and buffers the memory bus
  • 288-pin form factor fits the Supermicro H14SSF motherboard exactly

Teknik özellikler

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR44800-328K2
Capacity64GB (2 x 32GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 5600 (PC5 44800)
CAS LatencyCL46
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content64GB 2X32GB DDR5 5600MHz PC5-44800 2Rx8 1.1V 288-PIN ECC RDIMM KIT

Bu modelin diğer sürümleri

Aynı seriden 5 tane daha

Aynı aile, farklı bellek, soğutucu veya frekans — karar vermeden önce karşılaştırın.

Bu ürünle ilgili sorular

Is this 64GB 2x32GB DDR5 5600 kit the right capacity for my Supermicro H14SSF?

The kit provides 64GB total as two 32GB modules, matching the board's DDR5 RDIMM slot requirements; verify your manual for maximum supported capacity and approved population order before installing.

Will the DDR5 5600 CL46 speed run at full rate on the H14SSF?

The modules are spec-matched to the board's memory controller at 5600 MT/s with CL46 latency and 1.1V, so the system recognises them at rated speed when populated per the manufacturer's guidelines.

Does the 288-pin Registered ECC RDIMM form factor fit the H14SSF slots?

Yes, the 288-pin DDR5 RDIMM is the exact form factor the H14SSF requires; registered architecture and on-die ECC let every slot run fully populated while correcting single-bit errors.

Bu reyondan diğerleri

Müşteriler bunları karşılaştırdı

Aynı raf, aynı sipariş tamamlama — sekiz koin ve 30 dakikalık kur kilidi.