Kripto para kabul ediyoruz — böylece elinizdeki koinlerle gerçek donanım alabilirsiniz.Kripto parayla ödeyin, onu gerçek donanıma harcayın. $399 üzeri siparişlerde dünya genelinde sigortalı kargo ücretsizdir. Sade, markasız koliler Almanya’dan gönderilir.$399 üzeri siparişlerde sigortalı kargo ücretsizdir. Ödeme sayfası açıldığında kurunuz 30 dakika kilitli kalır.Kur 30 dakika kilitli. Her ürün mühürlüdür, seri numarası kontrol edilir ve 24 ay garanti kapsamındadır.Mühürlü, 24 ay garantili.

Favori ürünler Giriş yap
Green rectangular circuit board with gold edge connectors and black memory chips

OWC

OWC 8GB DDR4 2400 CL17 1Rx8 288-pin 1.2V Non-ECC UDIMM for QNAP TS-1677X TS-432XU TS-432PXU

SKU CH-WP10-WATSW

An 8 GB DDR4 2400 CL17 UDIMM module for QNAP TS-1677X and TS-432 series NAS systems

  • Capacity8GB
  • Type288-Pin DDR4 Non-ECC UDIMM
  • SpeedDDR4 2400 (PC4 19200)
  • CAS LatencyCL17
  • Voltage1.2V
  • ECCNo
  • 8GB capacity expands NAS multitasking headroom
  • DDR4 2400 CL17 speed matches QNAP specs
  • 2V low voltage reduces system power draw
  • 288-pin UDIMM fits TS-1677X and TS-432 series
  • JEDEC compliant ensures warranty-safe upgrade

QNAP-Validated DDR4 Upgrade

This 8 GB DDR4 module is built for the QNAP TS-1677X, TS-432XU, TS-432XU-RP, TS-432PXU and TS-432PXU-RP NAS platforms. It replaces OEM part numbers RAM-8GDR4A0-UD-2400 and RAM-8GDR4A1-UD-2400 directly. The non-ECC unbuffered design matches the factory memory specification for these systems.

JEDEC-Standard 288-Pin UDIMM

The stick uses a standard 288-pin DDR4 UDIMM form factor with no heat spreader, fitting the slim DIMM slots found in the listed QNAP units. Gold-edge contacts meet JEDEC and RoHS requirements for reliable seating. Installation is a tool-free DIY task that does not void the appliance warranty.

Single-Rank CL17 at 2400 MT/s

Rated at PC4-19200 with CAS latency 17, the module runs at 1.2 V and is backward compatible with 2133 MHz operation. The 1Rx8 organisation delivers 8 GB per slot, so total capacity depends on how many slots your specific NAS model provides. Buyers needing ECC error correction or registered buffering should choose a different module.

Öne çıkanlar

  • 8GB capacity expands NAS multitasking headroom
  • DDR4 2400 CL17 speed matches QNAP specs
  • 2V low voltage reduces system power draw
  • 288-pin UDIMM fits TS-1677X and TS-432 series
  • JEDEC compliant ensures warranty-safe upgrade

Teknik özellikler

BrandOWC
Part Number2U4D41R808GB
Capacity8GB
Type288-Pin DDR4 Non-ECC UDIMM
SpeedDDR4 2400 (PC4 19200)
CAS LatencyCL17
Voltage1.2V
ECCNo
Buffered/RegisteredUnbuffered
Rank1Rx8
Heat SpreaderNo
Compatible SystemQNAP TS-1677X
QNAP TS-432PXU
QNAP TS-432PXU-RP
QNAP TS-432XU
QNAP TS-432XU-RP

Bu modelin diğer sürümleri

Aynı seriden 5 tane daha

Aynı aile, farklı bellek, soğutucu veya frekans — karar vermeden önce karşılaştırın.

Bu ürünle ilgili sorular

What DDR4 speed and latency does this module run at?

It operates at DDR4 2400 (PC4-19200) with a CAS latency of 17.

What slot type and form factor does this 288-pin UDIMM require?

It fits a standard 288-pin DDR4 UDIMM slot in the compatible QNAP NAS models.

How is the module installed and what step is often missed?

Power off the NAS, open the chassis, align the notch with the slot key, press firmly until the retention clips click, then verify the new capacity in the QNAP firmware.

Bu reyondan diğerleri

Müşteriler bunları karşılaştırdı

Aynı raf, aynı sipariş tamamlama — sekiz koin ve 30 dakikalık kur kilidi.