Wij accepteren cryptovaluta — zo kunnen de munten die u bezit echte hardware kopen.Betaal in crypto, besteed het aan echte hardware. Gratis verzekerde verzending wereldwijd vanaf $399. Neutrale dozen zonder merk, verzonden vanuit Duitsland.Gratis verzekerde verzending vanaf $399. Uw koers wordt 30 minuten vastgezet zodra het afrekenen begint.Koers 30 minuten vastgezet. Elk artikel is verzegeld, het serienummer wordt gecontroleerd, en het valt onder 24 maanden garantie.Verzegeld, 24 maanden garantie.

Favoriete artikelen Inloggen
Green rectangular circuit board with gold edge connectors and black memory chips

OWC

OWC 8GB DDR4 2400 CL17 1Rx8 288-pin 1.2V Non-ECC UDIMM for QNAP TS-1677X TS-432XU TS-432PXU

SKU CH-WP10-WATSW

An 8 GB DDR4 2400 CL17 UDIMM module for QNAP TS-1677X and TS-432 series NAS systems

  • Capacity8GB
  • Type288-Pin DDR4 Non-ECC UDIMM
  • SpeedDDR4 2400 (PC4 19200)
  • CAS LatencyCL17
  • Voltage1.2V
  • ECCNo
  • 8GB capacity expands NAS multitasking headroom
  • DDR4 2400 CL17 speed matches QNAP specs
  • 2V low voltage reduces system power draw
  • 288-pin UDIMM fits TS-1677X and TS-432 series
  • JEDEC compliant ensures warranty-safe upgrade

QNAP-Validated DDR4 Upgrade

This 8 GB DDR4 module is built for the QNAP TS-1677X, TS-432XU, TS-432XU-RP, TS-432PXU and TS-432PXU-RP NAS platforms. It replaces OEM part numbers RAM-8GDR4A0-UD-2400 and RAM-8GDR4A1-UD-2400 directly. The non-ECC unbuffered design matches the factory memory specification for these systems.

JEDEC-Standard 288-Pin UDIMM

The stick uses a standard 288-pin DDR4 UDIMM form factor with no heat spreader, fitting the slim DIMM slots found in the listed QNAP units. Gold-edge contacts meet JEDEC and RoHS requirements for reliable seating. Installation is a tool-free DIY task that does not void the appliance warranty.

Single-Rank CL17 at 2400 MT/s

Rated at PC4-19200 with CAS latency 17, the module runs at 1.2 V and is backward compatible with 2133 MHz operation. The 1Rx8 organisation delivers 8 GB per slot, so total capacity depends on how many slots your specific NAS model provides. Buyers needing ECC error correction or registered buffering should choose a different module.

Pluspunten

  • 8GB capacity expands NAS multitasking headroom
  • DDR4 2400 CL17 speed matches QNAP specs
  • 2V low voltage reduces system power draw
  • 288-pin UDIMM fits TS-1677X and TS-432 series
  • JEDEC compliant ensures warranty-safe upgrade

Specificaties

BrandOWC
Part Number2U4D41R808GB
Capacity8GB
Type288-Pin DDR4 Non-ECC UDIMM
SpeedDDR4 2400 (PC4 19200)
CAS LatencyCL17
Voltage1.2V
ECCNo
Buffered/RegisteredUnbuffered
Rank1Rx8
Heat SpreaderNo
Compatible SystemQNAP TS-1677X
QNAP TS-432PXU
QNAP TS-432PXU-RP
QNAP TS-432XU
QNAP TS-432XU-RP

Andere versies van dit model

Nog 5 in dezelfde serie

Dezelfde familie, met ander geheugen, andere koeler of kloksnelheid — vergelijk voordat u beslist.

Vragen over dit artikel

What DDR4 speed and latency does this module run at?

It operates at DDR4 2400 (PC4-19200) with a CAS latency of 17.

What slot type and form factor does this 288-pin UDIMM require?

It fits a standard 288-pin DDR4 UDIMM slot in the compatible QNAP NAS models.

How is the module installed and what step is often missed?

Power off the NAS, open the chassis, align the notch with the slot key, press firmly until the retention clips click, then verify the new capacity in the QNAP firmware.

Ook in deze afdeling

Klanten vergeleken ook

Dezelfde afdeling, dezelfde kassa — acht munten en een koers die 30 minuten vaststaat.