Syba
Syba SY-PEX40166 6 Port SATA III PCIe 3.0 x1 Non-RAID Controller
Adds six SATA 6.0 Gb/s ports via a PCIe 3.0 x1 slot using a JMB582 chipset, supporting up to 10 drives with hot-plug and staggered spin-up
- Adds six SATA 6 Gb/s ports via PCIe 3.0 x1
- Hot-plug and staggered spin-up protect drives during changes
- Port multiplier support lets you connect more drives per port
- Driver-free AHCI operation works with Windows, Mac, Linux and NAS
- Low-profile card fits tight chassis while supporting up to ten drives
Six-port SATA III expansion
The Syba SY-PEX40166 adds six 6 Gb/s SATA ports through a single PCIe 3.0 x1 slot. It uses a JMB582 chipset and operates without RAID, presenting each drive directly to the operating system. No driver installation is required for Windows, macOS, Linux or NAS platforms.
Surveillance storage builders
This card suits installers who need up to ten SATA drives or optical drives in a low-profile slot without software RAID overhead. Builders who require hardware RAID levels, data redundancy or bootable RAID arrays should look at a dedicated RAID controller instead.
Shared bandwidth on ports one to five
Port 0 delivers the full 6.0 Gb/s link while ports 1 to 5 share a total of 6.0 Gb/s, limiting simultaneous throughput when multiple drives are active. Maximum sequential read or write speed is rated at 850 MB/s.
Öne çıkanlar
- Adds six SATA 6 Gb/s ports via PCIe 3.0 x1
- Hot-plug and staggered spin-up protect drives during changes
- Port multiplier support lets you connect more drives per port
- Driver-free AHCI operation works with Windows, Mac, Linux and NAS
- Low-profile card fits tight chassis while supporting up to ten drives
Teknik özellikler
Bu ürün için henüz yayınlanmış teknik özellik yok.
Bu ürünle ilgili sorular
What type of slot must my motherboard have for the SY-PEX40166 to install?
The card requires an available PCIe 3.0 x1 slot on the motherboard.
Will the five shared-bandwidth ports bottleneck my existing 6 Gb/s SATA drives?
Ports 1 to 5 share a total of 6.0 Gb/s bandwidth, so simultaneous heavy traffic on multiple drives will be limited to that aggregate throughput.
How can I verify each of the six ports is recognised at 6 Gb/s after installation?
Check the AHCI controller in Device Manager or run a drive benchmark; Port 0 should show a 6.0 Gb/s link while Ports 1–5 share that 6.0 Gb/s pool.
Bu reyondan diğerleri
Müşteriler bunları karşılaştırdı
Aynı raf, aynı sipariş tamamlama — sekiz koin ve 30 dakikalık kur kilidi.
