Black 1U rackmount UPS with LCD screen and six rear outlets

CyberPower

CyberPower CP1000PFCRM1U UPS 1000VA/600W 120V 1U Rackmount Sine Wave

SKU CH-C16J-WJ29X MPN CP1000PFCRM1U

1U rackmount UPS delivers 1000VA/600W pure sine-wave output with LCD status, six NEMA 5-15R outlets, USB and serial management ports, plus RJ45 network surge protection

International Version120V
Input Voltage Range88 - 144V
Input Frequency57 - 63 Hz
Input ConnectionNEMA 5-15P, Right Angle - 45° Offset
VA Rating1000 VA
Watts600 Watts

Pure sine wave output protects sensitive equipment
1U rackmount design fits standard server racks
1000 VA and 600 W capacity supports critical loads
1150 joule surge rating plus RJ45 data-line protection
LCD panel and USB or serial ports enable monitoring

485,99 щ.д.

0.00624233 BTC по днешния курс

В наличност · изпраща се днес

На касата курсът се заключва за 30 минути.

Доставка до Съединени щати ориентировъчно

UPS Worldwide Expedited 3–6 работни дни Безплатно
DHL Express Worldwide 2–3 работни дни 74,90 щ.д.

Вносните мита се начисляват от Вашата държава при пристигане.

Доставка на друг адрес

1U Rackmount Sine Wave UPS

The CyberPower CP1000PFCRM1U is a 1U rackmount uninterruptible power supply that delivers a pure sine wave output. It provides 1000VA and 600W of battery backup for servers, networking gear, and sensitive electronics in 120V environments.

Suited for standard 120V racks.

This unit suits administrators protecting rackmount equipment on a 120V supply with a NEMA 5-15P input. It is not for sites that operate on a different input voltage or that require longer battery runtime at full load than the unit provides.

600W output capacity decides the load

The 600W rating is the single specification that determines whether this UPS can support your connected equipment. Total attached draw must stay at or below this figure to maintain battery backup and surge protection.

Акценти

Pure sine wave output protects sensitive equipment
1U rackmount design fits standard server racks
1000 VA and 600 W capacity supports critical loads
1150 joule surge rating plus RJ45 data-line protection
LCD panel and USB or serial ports enable monitoring

Спецификации

Brand	CyberPower
Model	CP1000PFCRM1U
International Version	120V
Input Voltage Range	88 - 144V
Input Frequency	57 - 63 Hz
Input Connection	NEMA 5-15P, Right Angle - 45° Offset
VA Rating	1000 VA
Watts	600 Watts
Output Voltage	120Vac +/- 5%
Battery Type	Sealed Lead Acid
Battery Run Time	Runtime at Full Load: 1.5 min Runtime at Half Load: 10.5 min
Battery Recharge Time	8 Hours
Battery Replaceable	RB0670X4
Alarms	Battery Mode Low Battery Overload Fault
Interface Port	USB, Serial
Rackmountable	Yes
Data Line Protection	RJ45 1-in / 1-Out (10/100/1000)
Surge Energy Rating	1150 Joules
Protection	Internal Circuitry Limiting Circuit Breaker Protected
Dimensions	17.05" x 1.73" x 15.3"
Weight	30.2 lbs.
Тегло на пратката	15.79 kg
Размери на опаковката	533 × 503 × 147 mm

Въпроси за този артикул

What rack depth does the 17.05" x 1.73" x 15.3" chassis require?

The unit measures 15.3 inches deep, so the rack must provide at least that much usable depth behind the mounting rails.

Which cables must be connected during installation and which step is often missed?

Plug the NEMA 5-15P right-angle input into a 120 V branch circuit, attach loads to the six rear outlets, then connect the USB or serial cable so PowerPanel software can manage shutdowns; the data cable is the step most often skipped.

Which replacement battery kit is specified for this UPS and when should it be swapped?

The manufacturer lists kit RB0670X4; plan to replace the sealed lead-acid batteries after roughly three to five years or when runtime at half load drops well below 10.5 minutes.

Още от този рафт