NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Приемаме криптовалута — така монетите, които притежавате, могат да купят истински хардуер.Платете с крипто, похарчете го за истински хардуер. Безплатна застрахована доставка по целия свят над 399 $. Неутрални кашони без марка, изпратени от Германия.Безплатна застрахована доставка над 399 $. Курсът Ви е заключен за 30 минути веднага след отварянето на касата.Курс, заключен за 30 минути. Всеки артикул е запечатан, серийният му номер е проверен, и е покрит с 24-месечна гаранция.Запечатан, 24-месечна гаранция.
myVolts
An 1800 W AT power supply with active PFC, 90% conversion efficiency and 110–265 V input range, supporting eight graphics cards via 16 PCIe connectors
This AT-type power supply delivers 1800 W of rated output and is built to feed up to eight graphics cards in a mining machine. Active power-factor correction keeps the input range wide, letting the unit run on 220 V single-voltage lines between 180 V and 265 V or on a full-voltage span from 110 V to 265 V. The design targets builders who need dense multi-GPU power in a single chassis.
The unit provides a 20+4-pin motherboard connector and a 4+4-pin CPU connector, so verify that your board accepts these pin counts. Sixteen independent 6+2-pin GPU leads are included, alongside eight SATA drive connectors and three IDE fan headers. All output cables use copper conductors and are supplied in longer lengths for flexible routing inside large frames.
Conversion efficiency reaches 90 % or higher, far above the typical 70 % seen with passive PFC designs, so waste heat stays lower during round-the-clock operation. The active circuit holds output voltage steady even when mains voltage drifts across the 180–265 V window, protecting motherboards, drives and GPUs from the sags and spikes common on rural or industrial feeds. Not suited for builds that require fewer than eight GPU connectors or standard ATX form-factor mounting.
| Type | AT |
|---|
The supply ships with a 20+4-pin motherboard connector, a 4+4-pin CPU connector, sixteen 6+2-pin graphics connectors, eight SATA connectors and three IDE fan connectors. All output leads are copper and described as long. No extra cables are required for eight GPUs.
Select the 110V full-voltage model if your local mains can dip below 180V; it operates from 110V to 265V. Choose the 220V single-voltage model only where the supply stays between 180V and 265V.
1800W is the maximum continuous DC output the unit can deliver across all rails. With active PFC efficiency of 90% or higher, it supplies stable power to eight graphics cards, motherboard, CPU and drives while drawing less AC power than a passive-PFC design.
Още от този рафт
Същият рафт, същата каса — осем монети и заключване на курса за 30 минути.
Това, което изпращате, и това, в което четете цените.
Изпратено от Вашия портфейл при поръчката
Само за визуализация — каталогът е в долари
Никоя валута не съответства.
Изберете езика, на който сайтът да Ви говори.
Нови сте тук?
Вече имате профил?
Няма автоматично нулиране: този магазин не изпраща имейли, така че няма еднократна връзка, която да поискате. Оставете адреса в профила си и той ще бъде обработен ръчно.
Заявката е приета
Нищо няма да пристигне във Вашата пощенска кутия — този магазин изобщо не изпраща имейли. Заявките се обработват ръчно.
Спомнихте си я?