BFKK
BFKK 3U Rackmount Server Chassis EATX/ATX/MATX 4x5.25 6x3.5 Top/Side Cooling
- Rackmount
214,99 $
0.00277883BTC
Διαθέσιμο
Cisco Systems, Inc.
Cisco Systems, Inc. PWR-C1-715WAC-P= 715 W server power supply
Delivers 715 watt AC power with 80 Plus Platinum efficiency, weighing 3.59 lbs
- 715 W output powers demanding server workloads
- 80 Plus Platinum efficiency reduces energy waste and heat
- 59 lb lightweight design eases rack installation
- Hot-plug capable for zero-downtime maintenance
- Redundant-ready architecture supports high-availability deployments
715 W AC Server Power Supply
This 715 watt AC power supply is built for Cisco server chassis that accept the Configuration 1 form factor. It delivers 80 Plus Platinum efficiency for data-centre and enterprise deployments. The unit weighs 3.59 lbs and ships new as a spare or replacement module.
Replaces Failed or Lower-Capacity Units
It serves as a direct swap for a failed Configuration 1 supply or as an upgrade where the original chassis shipped with a lower-wattage module. The jump is worth it when the server load approaches the prior supply’s limit or when platinum efficiency reduces operating cost over time.
Platinum Efficiency and Form-Factor Limits
The 80 Plus Platinum rating sets the practical efficiency floor across typical load ranges. The Configuration 1 mechanical keying prevents installation in chassis wired for other Cisco supply types. No other interface or protocol constraints are defined by the supplied data.
Βασικά χαρακτηριστικά
- 715 W output powers demanding server workloads
- 80 Plus Platinum efficiency reduces energy waste and heat
- 59 lb lightweight design eases rack installation
- Hot-plug capable for zero-downtime maintenance
- Redundant-ready architecture supports high-availability deployments
Προδιαγραφές
Δεν έχουν δημοσιευτεί ακόμη προδιαγραφές για αυτό το προϊόν.
Ερωτήσεις για αυτό το προϊόν
What chassis or slot does the 715 W unit slide into?
It is a Configuration1 hot-plug module designed for Cisco Catalyst and Nexus switches that accept the same form factor.
How do you install the PWR-C1-715WAC-P= without triggering a power fault?
Insert the supply until the latch clicks, then verify the green input and output LEDs are both solid before applying load.
When should the 3.59 lb supply be swapped out under normal use?
Replace it when the status LED turns amber or the switch logs a power-supply degradation alert.
Επίσης σε αυτό το ράφι
Οι πελάτες σύγκριναν και αυτά
Ίδιο ράφι, ίδιο ταμείο — οκτώ νομίσματα και κλείδωμα ισοτιμίας 30 λεπτών.
