BFKK
BFKK 3U Rackmount Server Chassis EATX/ATX/MATX 4x5.25 6x3.5 Top/Side Cooling
- Rackmount
214,99 $
0.00277873BTC
Auf Lager
Cisco Systems, Inc.
Cisco Systems, Inc. PWR-C1-715WAC-P= 715 W server power supply
Delivers 715 watt AC power with 80 Plus Platinum efficiency, weighing 3.59 lbs
- 715 W output powers demanding server workloads
- 80 Plus Platinum efficiency reduces energy waste and heat
- 59 lb lightweight design eases rack installation
- Hot-plug capable for zero-downtime maintenance
- Redundant-ready architecture supports high-availability deployments
715 W AC Server Power Supply
This 715 watt AC power supply is built for Cisco server chassis that accept the Configuration 1 form factor. It delivers 80 Plus Platinum efficiency for data-centre and enterprise deployments. The unit weighs 3.59 lbs and ships new as a spare or replacement module.
Replaces Failed or Lower-Capacity Units
It serves as a direct swap for a failed Configuration 1 supply or as an upgrade where the original chassis shipped with a lower-wattage module. The jump is worth it when the server load approaches the prior supply’s limit or when platinum efficiency reduces operating cost over time.
Platinum Efficiency and Form-Factor Limits
The 80 Plus Platinum rating sets the practical efficiency floor across typical load ranges. The Configuration 1 mechanical keying prevents installation in chassis wired for other Cisco supply types. No other interface or protocol constraints are defined by the supplied data.
Besonderheiten
- 715 W output powers demanding server workloads
- 80 Plus Platinum efficiency reduces energy waste and heat
- 59 lb lightweight design eases rack installation
- Hot-plug capable for zero-downtime maintenance
- Redundant-ready architecture supports high-availability deployments
Technische Daten
Für diesen Artikel sind noch keine technischen Daten veröffentlicht.
Fragen zu diesem Artikel
What chassis or slot does the 715 W unit slide into?
It is a Configuration1 hot-plug module designed for Cisco Catalyst and Nexus switches that accept the same form factor.
How do you install the PWR-C1-715WAC-P= without triggering a power fault?
Insert the supply until the latch clicks, then verify the green input and output LEDs are both solid before applying load.
When should the 3.59 lb supply be swapped out under normal use?
Replace it when the status LED turns amber or the switch logs a power-supply degradation alert.
Ebenfalls in dieser Kategorie
Kunden haben diese ebenfalls verglichen
Gleiche Abteilung, gleiche Kasse — acht Kryptowährungen und ein für 30 Minuten fixierter Kurs.
