UOTEK UT-885 USB to RS-485 RS-422 Converter 5-pin Terminal Block
- CONVERTER
- Black
Δεχόμαστε κρυπτονομίσματα — έτσι ώστε αυτά που κατέχετε να μπορούν να αγοράσουν πραγματικό εξοπλισμό.Πληρώστε σε κρυπτονομίσματα, ξοδέψτε τα σε πραγματικό εξοπλισμό. Δωρεάν ασφαλισμένη αποστολή παγκοσμίως άνω των 399 $. Ουδέτερες κούτες αποστολής, χωρίς σήμανση, από τη Γερμανία.Δωρεάν ασφαλισμένη αποστολή άνω των 399 $. Η ισοτιμία σας κλειδώνει για 30 λεπτά μόλις ανοίξει το ταμείο.Κλείδωμα ισοτιμίας 30 λεπτών. Κάθε προϊόν είναι σφραγισμένο, ελεγμένο ως προς τον σειριακό αριθμό του, και καλύπτεται από εγγύηση 24 μηνών.Σφραγισμένο, με εγγύηση 24 μηνών.
SXDOOL
A 12 V 0.18 A 40 mm three-wire case fan with 37 mm diameter and 22 mm by 29 mm mounting holes
The SXDOOL COFAN F-4008H12BIV is a 12 V, 0.18 A axial fan designed for tight chassis locations. Its 37 mm frame fits small-form-factor cases, industrial enclosures and embedded boards where larger fans cannot mount. The three-wire connector provides tachometer feedback so the system can monitor rotor speed. Builders needing a low-profile airflow source for restricted spaces will find it suitable.
At the rated 12 V and 0.18 A the fan delivers its specified airflow for component cooling and general ventilation. Running at lower voltages reduces speed and noise but also cuts static pressure, limiting effectiveness against dense heatsinks or restrictive filters. The motor draws modest current, so it can be powered from standard motherboard headers or fan controllers without overloading them. It is not intended for high-static-pressure applications such as thick radiators.
The bundled three-wire cable adds a speed-sense line to the usual power and ground conductors. This allows the motherboard or a fan controller to report real-time RPM and trigger alerts if the rotor stalls. No PWM wire is present, so voltage regulation — not duty-cycle control — is the only way to adjust speed. No mounting screws, adapters or software utilities are included with the fan.
Δεν έχουν δημοσιευτεί ακόμη προδιαγραφές για αυτό το προϊόν.
Yes, the three-wire plug fits a standard 3-pin 12 V header and draws 0.18 A, so the board can read its speed signal.
Check the BIOS or monitoring software for an RPM reading on the corresponding fan header; a steady value confirms the tachometer wire is active.
Only the fan is supplied; screws to match the 22 mm × 29 mm mounting holes must be purchased separately.
Επίσης σε αυτό το ράφι
Ίδιο ράφι, ίδιο ταμείο — οκτώ νομίσματα και κλείδωμα ισοτιμίας 30 λεπτών.
Το νόμισμα στο οποίο πληρώνετε, και αυτό στο οποίο βλέπετε τις τιμές.
Αποστέλλεται από το πορτοφόλι σας στο ταμείο
Μόνο για προβολή — ο κατάλογος αναγράφεται σε δολάρια
Κανένα νόμισμα δεν αντιστοιχεί.
Επιλέξτε τη γλώσσα στην οποία σας μιλάει ο ιστότοπος.
Καμία γλώσσα δεν ταιριάζει.
Πρώτη επίσκεψη;
Έχετε ήδη λογαριασμό;
Δεν υπάρχει αυτόματη επαναφορά κωδικού: αυτό το κατάστημα δεν στέλνει e-mail, άρα δεν υπάρχει σύνδεσμος μίας χρήσης να ζητήσετε. Αφήστε τη διεύθυνση στον λογαριασμό σας και κάποιος θα την επεξεργαστεί με το χέρι.
Το αίτημα καταχωρίστηκε
Δεν θα λάβετε τίποτα στα εισερχόμενά σας — το κατάστημα δεν στέλνει κανένα e-mail. Κάποιος το διαχειρίζεται με το χέρι.
Τον θυμηθήκατε;