UOTEK UT-885 USB to RS-485 RS-422 Converter 5-pin Terminal Block
- CONVERTER
- Black
Sprejemamo kriptovalute — tako lahko sredstva, ki jih imate, kupijo pravo strojno opremo.Plačajte v kriptovaluti, zapravite jo za pravo strojno opremo. Brezplačna zavarovana dostava po vsem svetu nad 399 $. Nevtralni kartoni brez znamke, poslani iz Nemčije.Brezplačna zavarovana dostava nad 399 $. Vaš tečaj je zaklenjen za 30 minut, takoj ko se odpre blagajna.Tečaj zaklenjen 30 minut. Vsak izdelek je zapečaten, njegova serijska številka preverjena, in krit z 24-mesečno garancijo.Zapečateno, 24-mesečna garancija.
SXDOOL
A 12 V 0.18 A 40 mm three-wire case fan with 37 mm diameter and 22 mm by 29 mm mounting holes
The SXDOOL COFAN F-4008H12BIV is a 12 V, 0.18 A axial fan designed for tight chassis locations. Its 37 mm frame fits small-form-factor cases, industrial enclosures and embedded boards where larger fans cannot mount. The three-wire connector provides tachometer feedback so the system can monitor rotor speed. Builders needing a low-profile airflow source for restricted spaces will find it suitable.
At the rated 12 V and 0.18 A the fan delivers its specified airflow for component cooling and general ventilation. Running at lower voltages reduces speed and noise but also cuts static pressure, limiting effectiveness against dense heatsinks or restrictive filters. The motor draws modest current, so it can be powered from standard motherboard headers or fan controllers without overloading them. It is not intended for high-static-pressure applications such as thick radiators.
The bundled three-wire cable adds a speed-sense line to the usual power and ground conductors. This allows the motherboard or a fan controller to report real-time RPM and trigger alerts if the rotor stalls. No PWM wire is present, so voltage regulation — not duty-cycle control — is the only way to adjust speed. No mounting screws, adapters or software utilities are included with the fan.
Za ta izdelek še ni objavljenih specifikacij.
Yes, the three-wire plug fits a standard 3-pin 12 V header and draws 0.18 A, so the board can read its speed signal.
Check the BIOS or monitoring software for an RPM reading on the corresponding fan header; a steady value confirms the tachometer wire is active.
Only the fan is supplied; screws to match the 22 mm × 29 mm mounting holes must be purchased separately.
Tudi v tem oddelku
Ista polica, ista blagajna — osem kriptovalut in 30-minutni zaklep tečaja.
V čem plačujete in v čem berete cene.
Poslano iz Vaše denarnice ob blagajni
Samo za prikaz — katalog je cenovno izražen v dolarjih
Nobena valuta ne ustreza.
Izberite jezik, v katerem Vam govori spletna stran.
Ni ustreznega jezika.
Prvič tu?
Že imate račun?
Samodejne ponastavitve ni: ta trgovina ne pošilja e-pošte, zato ni enkratne povezave, ki bi jo lahko zahtevali. Pustite naslov na računu — nekdo ga bo obravnaval ročno.
Zahteva zabeležena
V Vašo elektronsko pošto ne prihaja nič — ta trgovina ne pošilja nobene e-pošte. Zahteve nekdo obravnava ročno.
Ste se spomnili?