UOTEK UT-885 USB to RS-485 RS-422 Converter 5-pin Terminal Block
- CONVERTER
- Black
Приемаме криптовалута — така монетите, които притежавате, могат да купят истински хардуер.Платете с крипто, похарчете го за истински хардуер. Безплатна застрахована доставка по целия свят над 399 $. Неутрални кашони без марка, изпратени от Германия.Безплатна застрахована доставка над 399 $. Курсът Ви е заключен за 30 минути веднага след отварянето на касата.Курс, заключен за 30 минути. Всеки артикул е запечатан, серийният му номер е проверен, и е покрит с 24-месечна гаранция.Запечатан, 24-месечна гаранция.
SXDOOL
A 12 V 0.18 A 40 mm three-wire case fan with 37 mm diameter and 22 mm by 29 mm mounting holes
The SXDOOL COFAN F-4008H12BIV is a 12 V, 0.18 A axial fan designed for tight chassis locations. Its 37 mm frame fits small-form-factor cases, industrial enclosures and embedded boards where larger fans cannot mount. The three-wire connector provides tachometer feedback so the system can monitor rotor speed. Builders needing a low-profile airflow source for restricted spaces will find it suitable.
At the rated 12 V and 0.18 A the fan delivers its specified airflow for component cooling and general ventilation. Running at lower voltages reduces speed and noise but also cuts static pressure, limiting effectiveness against dense heatsinks or restrictive filters. The motor draws modest current, so it can be powered from standard motherboard headers or fan controllers without overloading them. It is not intended for high-static-pressure applications such as thick radiators.
The bundled three-wire cable adds a speed-sense line to the usual power and ground conductors. This allows the motherboard or a fan controller to report real-time RPM and trigger alerts if the rotor stalls. No PWM wire is present, so voltage regulation — not duty-cycle control — is the only way to adjust speed. No mounting screws, adapters or software utilities are included with the fan.
Все още няма публикувани спецификации за този артикул.
Yes, the three-wire plug fits a standard 3-pin 12 V header and draws 0.18 A, so the board can read its speed signal.
Check the BIOS or monitoring software for an RPM reading on the corresponding fan header; a steady value confirms the tachometer wire is active.
Only the fan is supplied; screws to match the 22 mm × 29 mm mounting holes must be purchased separately.
Още от този рафт
Същият рафт, същата каса — осем монети и заключване на курса за 30 минути.
Това, което изпращате, и това, в което четете цените.
Изпратено от Вашия портфейл при поръчката
Само за визуализация — каталогът е в долари
Никоя валута не съответства.
Изберете езика, на който сайтът да Ви говори.
Няма съвпадащ език.
Нови сте тук?
Вече имате профил?
Няма автоматично нулиране: този магазин не изпраща имейли, така че няма еднократна връзка, която да поискате. Оставете адреса в профила си и той ще бъде обработен ръчно.
Заявката е приета
Нищо няма да пристигне във Вашата пощенска кутия — този магазин изобщо не изпраща имейли. Заявките се обработват ръчно.
Спомнихте си я?