Me võtame vastu krüptoraha — nii saab teie hoitav krüptoraha osta päris riistvara.Makske krüptorahaga, kulutage seda päris riistvarale. Tasuta kindlustatud tarne kogu maailmas, üle 399 $. Lihtsad, kaubamärgita väliskarbid, saadetud Saksamaalt.Tasuta kindlustatud tarne üle 399 $. Teie kurss lukustatakse 30 minutiks kohe, kui kassa avaneb.Kurss lukustatud 30 minutiks. Iga toode on pitseeritud, selle seerianumber on kontrollitud ja sellel kehtib 24-kuuline garantii.Pitseeritud, 24-kuulise garantiiga.

Hinnavaatlus Logi sisse
Silver compression fitting for 16mm rigid tubing

Bitspower

Bitspower BP-EMLA16 G1/4" Multi-Link Fitting 16mm OD Silver

SKU CH-DD8E-TFCD5 MPN BP-EMLA16

Connects 16mm rigid tubing with a G1/4" multi-link brass fitting in silver

  • TypeFittings
  • Multi-link design enables extended rigid-tube runs
  • G1/4" thread fits standard water-cooling components
  • Brass construction resists corrosion in liquid loops
  • Silver Shining finish matches metallic build themes
  • Compression seal secures 16mm OD hard tubing

G1/4" Multi-Link Fitting for 16mm OD Tubing

This compression fitting connects 16mm OD rigid tubing in custom liquid-cooling loops. It is intended for builders assembling hard-tube systems who need secure, leak-free joints with a clean silver finish.

Brass construction and compression seal

The fitting is machined from high-quality brass and uses a compression design that grips rigid tubing tightly when assembled correctly. RoHS-compliant materials meet environmental standards without affecting thermal performance or acoustic profile of the loop.

Extends existing hard-tube runs

The multi-link design allows straight extensions or angled connections between 16mm OD tubes without adding extra components. Builders replacing push-fit couplers or upgrading from soft tubing gain a more rigid, maintenance-friendly joint; those needing quick-disconnect or smaller-diameter connections should look elsewhere.

Põhijooned

  • Multi-link design enables extended rigid-tube runs
  • G1/4" thread fits standard water-cooling components
  • Brass construction resists corrosion in liquid loops
  • Silver Shining finish matches metallic build themes
  • Compression seal secures 16mm OD hard tubing

Tehnilised andmed

TypeFittings

Küsimused selle toote kohta

How do I install the Bitspower BP-EMLA16 multi-link fitting onto 16mm OD hard tubing without leaks?

Cut the tubing square, deburr the edge, slide the compression nut and ring onto the tube, push the tube fully into the fitting body until it seats, then hand-tighten the nut firmly — the step most people skip is verifying the tube bottoms out before tightening.

What maintenance will the BP-EMLA16 fitting need over time?

Check the compression seal and O-ring whenever you drain the loop; if the O-ring shows flattening or the nut has backed off, replace the O-ring and re-torque the nut to keep the joint secure.

What is the first limitation I will hit when running the BP-EMLA16 under sustained load?

The G1/4" thread depth and brass construction set the mechanical and thermal limit — ensure the mating port provides full thread engagement so the joint stays sealed at operating temperature.

Veel samast osakonnast

Kliendid võrdlesid neid ka

Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.