Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Silver compression fitting for 16mm rigid tubing

Bitspower

Bitspower BP-EMLA16 G1/4" Multi-Link Fitting 16mm OD Silver

SKU CH-DD8E-TFCD5 MPN BP-EMLA16

Connects 16mm rigid tubing with a G1/4" multi-link brass fitting in silver

  • TypeFittings
  • Multi-link design enables extended rigid-tube runs
  • G1/4" thread fits standard water-cooling components
  • Brass construction resists corrosion in liquid loops
  • Silver Shining finish matches metallic build themes
  • Compression seal secures 16mm OD hard tubing

G1/4" Multi-Link Fitting for 16mm OD Tubing

This compression fitting connects 16mm OD rigid tubing in custom liquid-cooling loops. It is intended for builders assembling hard-tube systems who need secure, leak-free joints with a clean silver finish.

Brass construction and compression seal

The fitting is machined from high-quality brass and uses a compression design that grips rigid tubing tightly when assembled correctly. RoHS-compliant materials meet environmental standards without affecting thermal performance or acoustic profile of the loop.

Extends existing hard-tube runs

The multi-link design allows straight extensions or angled connections between 16mm OD tubes without adding extra components. Builders replacing push-fit couplers or upgrading from soft tubing gain a more rigid, maintenance-friendly joint; those needing quick-disconnect or smaller-diameter connections should look elsewhere.

Helstu kostir

  • Multi-link design enables extended rigid-tube runs
  • G1/4" thread fits standard water-cooling components
  • Brass construction resists corrosion in liquid loops
  • Silver Shining finish matches metallic build themes
  • Compression seal secures 16mm OD hard tubing

Tæknilýsing

TypeFittings

Spurningar um þessa vöru

How do I install the Bitspower BP-EMLA16 multi-link fitting onto 16mm OD hard tubing without leaks?

Cut the tubing square, deburr the edge, slide the compression nut and ring onto the tube, push the tube fully into the fitting body until it seats, then hand-tighten the nut firmly — the step most people skip is verifying the tube bottoms out before tightening.

What maintenance will the BP-EMLA16 fitting need over time?

Check the compression seal and O-ring whenever you drain the loop; if the O-ring shows flattening or the nut has backed off, replace the O-ring and re-torque the nut to keep the joint secure.

What is the first limitation I will hit when running the BP-EMLA16 under sustained load?

The G1/4" thread depth and brass construction set the mechanical and thermal limit — ensure the mating port provides full thread engagement so the joint stays sealed at operating temperature.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.