Me võtame vastu krüptoraha — nii saab teie hoitav krüptoraha osta päris riistvara.Makske krüptorahaga, kulutage seda päris riistvarale. Tasuta kindlustatud tarne kogu maailmas, üle 399 $. Lihtsad, kaubamärgita väliskarbid, saadetud Saksamaalt.Tasuta kindlustatud tarne üle 399 $. Teie kurss lukustatakse 30 minutiks kohe, kui kassa avaneb.Kurss lukustatud 30 minutiks. Iga toode on pitseeritud, selle seerianumber on kontrollitud ja sellel kehtib 24-kuuline garantii.Pitseeritud, 24-kuulise garantiiga.

Hinnavaatlus Logi sisse
Rectangular silver metal power supply unit with fan grille and label sticker

HP

HP 702307-002 PS-4241-1HC power supply for EliteDesk 800 G1 SFF and ProDesk 400 G1

SKU CH-DWPT-NMNCX

Replacement 400 W unit for EliteDesk 800 G1 SFF and ProDesk 400 G1 systems

  • OEM HP power supply fits EliteDesk 800 G1 SFF
  • Direct replacement for ProDesk 400 G1 systems
  • Part number 702307-002 ensures exact compatibility
  • New condition ready for immediate installation

HP 702307-002 PS-4241-1HC for EliteDesk 800 G1 SFF

This OEM power supply replaces the original unit in HP EliteDesk 800 G1 SFF and ProDesk 400 G1 systems. It fits the proprietary form factor and connector layout used by those models. Buyers needing a standard ATX pinout or higher wattage for discrete graphics upgrades cannot use this part.

Thermals noise and power draw in normal use

The supply delivers the rated output for the factory configuration of the supported desktops. Fan speed is managed by the system BIOS under typical office workloads. No independent efficiency certification or acoustic rating is provided for this unit.

Põhijooned

  • OEM HP power supply fits EliteDesk 800 G1 SFF
  • Direct replacement for ProDesk 400 G1 systems
  • Part number 702307-002 ensures exact compatibility
  • New condition ready for immediate installation

Tehnilised andmed

Selle toote kohta ei ole veel tehnilisi andmeid avaldatud.

Küsimused selle toote kohta

How do I install the PS-4241-1HC power supply in my EliteDesk 800 G1 SFF and which step is often missed?

Remove the side panel, unplug the 24-pin and 4-pin cables from the old unit, unscrew the four retaining screws, slide the new PS-4241-1HC into the chassis, refit the screws, reconnect both power cables, and ensure the 4-pin CPU connector is fully seated — it is the step most often left loose.

What maintenance or replacement will the PS-4241-1HC need over time?

The internal fan bearings will eventually wear; plan to replace the entire PS-4241-1HC unit when fan noise increases or voltages drift, as no user-serviceable parts are inside.

Veel samast osakonnast

Kliendid võrdlesid neid ka

Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.