Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Rectangular silver metal power supply unit with fan grille and label sticker

HP

HP 702307-002 PS-4241-1HC power supply for EliteDesk 800 G1 SFF and ProDesk 400 G1

SKU CH-DWPT-NMNCX

Replacement 400 W unit for EliteDesk 800 G1 SFF and ProDesk 400 G1 systems

  • OEM HP power supply fits EliteDesk 800 G1 SFF
  • Direct replacement for ProDesk 400 G1 systems
  • Part number 702307-002 ensures exact compatibility
  • New condition ready for immediate installation

HP 702307-002 PS-4241-1HC for EliteDesk 800 G1 SFF

This OEM power supply replaces the original unit in HP EliteDesk 800 G1 SFF and ProDesk 400 G1 systems. It fits the proprietary form factor and connector layout used by those models. Buyers needing a standard ATX pinout or higher wattage for discrete graphics upgrades cannot use this part.

Thermals noise and power draw in normal use

The supply delivers the rated output for the factory configuration of the supported desktops. Fan speed is managed by the system BIOS under typical office workloads. No independent efficiency certification or acoustic rating is provided for this unit.

Helstu kostir

  • OEM HP power supply fits EliteDesk 800 G1 SFF
  • Direct replacement for ProDesk 400 G1 systems
  • Part number 702307-002 ensures exact compatibility
  • New condition ready for immediate installation

Tæknilýsing

Engin birt tæknilýsing fyrir þessa vöru enn.

Spurningar um þessa vöru

How do I install the PS-4241-1HC power supply in my EliteDesk 800 G1 SFF and which step is often missed?

Remove the side panel, unplug the 24-pin and 4-pin cables from the old unit, unscrew the four retaining screws, slide the new PS-4241-1HC into the chassis, refit the screws, reconnect both power cables, and ensure the 4-pin CPU connector is fully seated — it is the step most often left loose.

What maintenance or replacement will the PS-4241-1HC need over time?

The internal fan bearings will eventually wear; plan to replace the entire PS-4241-1HC unit when fan noise increases or voltages drift, as no user-serviceable parts are inside.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.