NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Me võtame vastu krüptoraha — nii saab teie hoitav krüptoraha osta päris riistvara.Makske krüptorahaga, kulutage seda päris riistvarale. Tasuta kindlustatud tarne kogu maailmas, üle 399 $. Lihtsad, kaubamärgita väliskarbid, saadetud Saksamaalt.Tasuta kindlustatud tarne üle 399 $. Teie kurss lukustatakse 30 minutiks kohe, kui kassa avaneb.Kurss lukustatud 30 minutiks. Iga toode on pitseeritud, selle seerianumber on kontrollitud ja sellel kehtib 24-kuuline garantii.Pitseeritud, 24-kuulise garantiiga.
Kingston Technology Corp.
64 GB DDR5-6400 ECC registered dual-rank module with CL52 latency and 1.10 V operation for server motherboards
This 64GB DDR5 kit contains eight 8GB modules running at 6400 MT/s with CL52 latency. Registered signal processing and on-die ECC protect data integrity in multi-socket servers and workstations. The 1.10V operating voltage matches the DDR5 baseline for dense configurations. Modules use Hynix 2Rx4 ICs on standard 288-pin DIMM PCBs.
Registered buffering and the low 1.10V rail keep per-module power modest even with eight ranks populated. Passive operation is typical in chassis with directed airflow; no heat spreaders are fitted. The tRAC of 32ns and 52-52-52 timings indicate standard JEDEC DDR5-6400 behaviour under sustained server loads.
Registered clock drivers reduce electrical load on the memory controller, allowing all eight DIMM slots to be filled without signal degradation. On-die ECC corrects single-bit errors inside each DRAM chip before data leaves the module. The combination targets uptime-critical workloads rather than low-latency desktop or overclocking use.
| Brand | Kingston |
|---|---|
| Model | KSM64R52BD4-64HA |
| Capacity | 64GB (8 x 8GB) |
| Type | 288-Pin DDR5 SDRAM |
| Speed | DDR5 6400 (PC5 51200) |
| CAS Latency | CL52 |
| Timing | 52-52-52 |
| tRAC | 32ns |
| Voltage | 1.10V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Chipset | Hynix Chipset |
| Heat Spreader | No |
| Tarnekaal | 0.05 kg |
| Pakendi mõõtmed | 161 × 44 × 9 mm |
Align the notch on the module with the key in the server motherboard slot, press firmly until both retaining clips lock, then verify in BIOS that ECC and registered mode are enabled for the 2Rx4 configuration.
No scheduled maintenance is required; the modules have no heat spreader and run at 1.10V, so replacement is only necessary if a DIMM fails or the platform is upgraded beyond DDR5-6400.
The CL52 latency at 6400 MT/s sets the throughput ceiling; sustained workloads will hit bandwidth limits before thermal throttling because the modules operate at 1.10V without a spreader.
Veel samast osakonnast
Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.
See, millega maksate, ja see, milles vaatate hindu.
Saadetud teie rahakotist kassas
Ainult kuvamiseks — kataloogi hinnad on dollarites
Ükski vääring ei vasta sellele.
Valige keel, milles sait teiega räägib.
Esimest korda siin?
Teil on juba konto?
Automaatset lähtestamist ei ole: see pood ei saada ühtegi e-kirja, seega pole ka ühekordset linki, mida küsida. Jätke aadress kontole alles, seda käsitletakse käsitsi.
Päring registreeritud
Teie postkasti ei jõua midagi — see pood ei saada e-kirju üldse. Keegi tegeleb sellega käsitsi.
Tuli meelde?